Re: Epson 1200U and Sane - not quite
I fought this exact same problem two nights ago with a 1240U. You might
check /etc/sane.d/epson.conf and make sure the parameters are set
correctly. I ended up having to install everything from source.
On Thu, 2003-03-06 at 15:43, Ian Melnick wrote:
> Hello, all
>
> I have an Epson Perfection 1200U scanner. I used mknod to make the
> scanner0 device node in /dev/usb as noted in the documentation, and I
> turn it on. xsane can't find any scanner devices, so I run
> sane-find-scanner and it finds it just fine. So I run scanimage -L but
> it can't find anything. So I run scanimage -d epson:/dev/usb/scanner0,
> and the light on the scanner blinks for a sec and then nothing happens.
> After a few minutes I get a message on the console:
> kilusb_control/bulk_msg: timeout ... but the program doesn't quit. Why
> is this happening, and what should I do to get it to work? According to
> the docs, this model has been "supported" for a while.
>
> Thanks
>
>
> --
> To UNSUBSCRIBE, email to debian-user-request@lists.debian.org
> with a subject of "unsubscribe". Trouble? Contact listmaster@lists.debian.org
>
--
steve
___________________________________________________
| |
| it puts the lotion on its skin ... |
| |
| http://monticello.biz : tomorrow's tech today |
| http://exitwound.org : hard to find |
| http://exitwound.org/wiki : experimental |
| http://buckowensfan.com : he's the man |
---------------------------------------------------
Reply to: