Re: Help needed w/ PLIP connection
Run as root
#plipconfig plip0
Good Luck
brf
> Hi all:
>
> I am having trouble debugging my plip connection.
> I get clean kernel messages on bootup to the fact that the plip modules
> are loaded etc.
> On machine is euler and the other is gauss.
> I have some out put from both boxxess.
> I have used the plip cable before at work so I know that it is
> working correctly.
>
> I tried to ping the remote box unsuccessfully.
> EULER:~# ping 192.168.2.2
> PING 192.168.2.2 (192.168.2.2): 56 data bytes
>
>
> --- 192.168.2.2 ping statistics ---
> 20 packets transmitted, 0 packets received, 100% packet loss
>
>
> ********* I hit ctrl c after 1 min of no repsonse
>
>
> EULER:~# ifconfig plip0
> plip0 Link encap:Ethernet HWaddr FC:FC:C0:A8:02:01
> inet addr:192.168.2.1 P-t-P:192.168.2.2 Mask:255.255.255.255
> UP POINTOPOINT RUNNING NOARP MTU:1500 Metric:1
> RX packets:0 errors:0 dropped:0 overruns:0 frame:0
> TX packets:31 errors:0 dropped:0 overruns:0 carrier:0
> collisions:0 txqueuelen:10
> RX bytes:0 (0.0 b) TX bytes:3038 (2.9 KiB)
> Interrupt:7 Base address:0x378
>
>
>
> EULER:~# cat /etc/network/interfaces
> # /etc/network/interfaces -- configuration file for ifup(8), ifdown(8)
>
> # The loopback interface
> auto lo
> iface lo inet loopback
>
> # The first network card - this entry was created during the Debian
> installation
> # (network, broadcast and gateway are optional)
> auto eth0
> iface eth0 inet static
> address 192.168.1.2
> netmask 255.255.255.0
> network 192.168.1.0
> broadcast 192.168.1.255
> gateway 192.168.1.1
>
> auto eth1
> iface eth1 inet static
> address 192.168.4.1
> netmask 255.255.255.0
> network 192.168.4.0
> broadcast 192.168.4.255
>
> auto plip0
> iface plip0 inet static
> address 192.168.2.1
> netmask 255.255.255.255
> pointopoint 192.168.2.2
>
>
> EULER:~# cat /etc/modutils/parport
> options parport_pc io=0x378,0xac00 irq=auto,auto
> options plip parport=0
> options lp parport=1
>
>
>
> EULER:~# route
> Kernel IP routing table
> Destination Gateway Genmask Flags Metric Ref Use
> Iface bigtime-loopbac * 255.255.255.255 UH 1 0 0
> sl0 192.168.2.2 * 255.255.255.255 UH 0 0 0
> plip0 192.168.4.0 * 255.255.255.0 U 0 0 0
> eth1 localnet * 255.255.255.0 U0 0 0
> eth0 default 192.168.1.1 0.0.0.0UG 0 0 0 eth0
> default * 0.0.0.0U 1 0 0 sl0
>
>
> EULER:~# route -n
> Kernel IP routing table
> Destination Gateway Genmask Flags Metric Ref Use
> Iface 209.123.12.26 0.0.0.0 255.255.255.255 UH 1 00
> sl0 192.168.2.2 0.0.0.0 255.255.255.255 UH 0 00
> plip0 192.168.4.0 0.0.0.0 255.255.255.0 U 00 0
> eth1 192.168.1.0 0.0.0.0 255.255.255.0 U0 0 0
> eth0 0.0.0.0 192.168.1.1 0.0.0.0UG 0 0 0 eth0
> 0.0.0.0 0.0.0.0 0.0.0.0U 1 0 0 sl0
>
>
>
>
>
> Other PC
>
>
> I also to tried to ping the remote box unsuccessfully.
> gauss:~# ping 192.168.2.1
> PING 192.168.2.1 (192.168.2.1): 56 data bytes
>
> --- 192.168.2.1 ping statistics ---
> 10 packets transmitted, 0 packets received, 100% packet loss
>
> gauss:~# ifconfig plip0
> plip0 Link encap:Ethernet HWaddr FC:FC:C0:A8:02:02
> inet addr:192.168.2.2 P-t-P:192.168.2.1 Mask:255.255.255.255
> UP POINTOPOINT RUNNING NOARP MTU:1500 Metric:1
> RX packets:31 errors:0 dropped:0 overruns:0 frame:0
> TX packets:0 errors:59 dropped:0 overruns:0 carrier:59
> collisions:0 txqueuelen:10
> RX bytes:3038 (2.9 KiB) TX bytes:0 (0.0 b)
> Interrupt:7 Base address:0x378
>
>
> gauss:~# cat /etc/network/interfaces
> # /etc/network/interfaces -- configuration file for ifup(8), ifdown(8)
>
> # The loopback interface
> auto lo
> iface lo inet loopback
>
> # The first network card - this entry was created during the Debian
> installation
> # (network, broadcast and gateway are optional)
>
> auto plip0
> iface plip0 inet static
> address 192.168.2.2
> netmask 255.255.255.255
> pointopoint 192.168.2.1
>
>
>
>
>
> gauss:~# cat /etc/modutils/parport
> options parport_pc io=0x378 irq=7
> #options lp parport=0
> # printing done via local network at home
> options plip parport=0
>
>
> gauss:~# route
> Kernel IP routing table
> Destination Gateway Genmask Flags Metric Ref Use
> Iface 192.168.2.1 * 255.255.255.255 UH 0 0
> 0 plip0
>
>
> gauss:~# route -n
> Kernel IP routing table
> Destination Gateway Genmask Flags Metric Ref Use
> Iface 192.168.2.1 0.0.0.0 255.255.255.255 UH 0 0
> 0 plip0 gauss:~#
>
>
> TIA
>
> Brian
>
>
>
>
> --
> To UNSUBSCRIBE, email to debian-user-request@lists.debian.org
> with a subject of "unsubscribe". Trouble? Contact
> listmaster@lists.debian.org
Reply to: