Re: Problems building 2.4.19 kernel from source
bob parker wrote:
>
> I installed the binary kernel 2.4.18-k7 successfully on my Duron box.
> Next i downloaded the source for 2.4.19 from www.kernel.org.
> I copied the .config from /boot/config-2.4.18-k7 and did a make menuconfig and
> just accepted all of the defaults because my box seems to be going ok.
> Then make dep followed by make bzImage, then make modules.
> That last step took quite some time and at the end there was a line 'Nothing
> to be done for modules'
> make modules-install gave the message
> *** no rule to make target
> I find this puzzling because 'M' options abound in the .config file
>
> Pointers anyone?
Isn't there meant to be a "make clean" in there somewhere?
Reply to: