Re: eth0

[Curtis Vaughan <curtis@npc-usa.com>]

OK, I'm wondering if the problem has to do with changes i made to 
/etc/default/pcmcia, based on advice from this forum.  Currently, 
PCIC=yenta_socket (I am using woody!).  I'm now thinking it should be 
xircom_cb.  Can anyone confirm this?


On Thursday 21 February 2002 11:36 am, Curtis Vaughan wrote:
> OH! I've discovered the following.
> ifconfig lo
> shows that lo has no IP address!!!!!
>
> On Thursday 21 February 2002 11:12 am, Curtis Vaughan wrote:
> > Rebooted.  Same results.  Included below are changes I made to the
> > network.opts file.  Also, should I reenter eth0 in my interfaces file in
> > the line:
> >
> > auto lo
> >
> >     IPADDR="10.0.0.33"
> >     NETMASK="255.255.255.0"
> >     NETWORK="10.0.0.0"
> >     BROADCAST="10.0.0.255"
> >     # Gateway address for static routing
> >     GATEWAY="10.0.0.254"
> >
> > The DHCP entry is set to "n".
> >
> > Curtis
> >
> > PS.  BTW, I don't know where the question marks came from.
> >
> > On Thursday 21 February 2002 10:47 am, Curtis Vaughan wrote:
> > > Thanks to Nathan for the advise.  I have edited the network.opts file
> > > the way I think it should be.  Besides the information provided within
> > > the network.opts file itself, whereas can I find info for editing it? 
> > > There is no man entry.
> > >
> > > After I reboot I will report as to the results.