Re: USB Printer Setup Problem
On Fri, Jan 18, 2002 at 10:43:14AM -0500, Jerome Acks Jr wrote:
> On Thu, Jan 17, 2002 at 04:23:00PM -0500, Thomas H. George,,, wrote:
> > I have an Epson StylusColor 860 which I wish to use on a usb port. I
> > compiled my 2.2.19 kernel with usb support, usb file support and usb
> > printer. cat /proc/bus/usb/devices is emplty, cat /proc/bus/usb/drivers
>
> I would expect /proc/bus/usb/devices to at least list your USB root hub.
> On boot or when you first load usbcore.o and usb-uhci.o/uhci.o/ohci.o
> modules, what is logged in /var/log/messages?
The following lines are in /var/log/messages:
usb.c: registered new driver usblp
usb.c: registered new driver usbdevfs
usb.c: registered new driver hub
but still /proc/bus/usb/devices is an empty file.
>
> > shows:
> >
> > hub
> > usbdevfs
> > 0- 15: usblp
> >
> > I have checked BIOS (and that other operating? system accesses the
> > printer with no difficulty). One reference lists a long series of codes
> > to be sent by uniprint to wake up the printer in usb mode but apt-get
> > doesn't know about uniprint.
> >
> > Is there a good stable solution to this problem?
> >
> >
> > --
> > To UNSUBSCRIBE, email to debian-user-request@lists.debian.org
> > with a subject of "unsubscribe". Trouble? Contact
> > listmaster@lists.debian.org
> >
>
> --
> Jerome
>
>
> --
> To UNSUBSCRIBE, email to debian-user-request@lists.debian.org
> with a subject of "unsubscribe". Trouble? Contact listmaster@lists.debian.org
>
Reply to: