Re: Problem with XFree 4.0 .

[cjw44@flatline.org.uk (Colin Watson)]

Peter Good <psgood@petesinternet.net> wrote:
>Colin Watson wrote:
>> G0DModE <g0dmode@data.pl> wrote:
>> >After unpacking the XFree 4.0 soft, I wanted to configure it, so I run
>> >"XFree86 -configure" command and the output was: "Segmentation fault". I
>> >tried to install over and over again, but always output was the same.
>> 
>> Where did you get that command from? :)
>
>(snipped from the XFree86 4.0 Install file)
>The next step is to configure the X server.  That is covered in detail
>in an as-yet unwritten document :-(.  In the meantime, there are two
>ways to create a basic X server configuration file for XFree86 4.0.
>One is to run the xf86config utility.  Another is to use the new
>-configure X server option:
> 
>     XFree86 -configure           
>(End of snip)
>
>Thats where he would have got that command from.

Bah. In that case, somebody ought to update the man page in the
documentation on the web. :(

Sorry about that,

-- 
Colin Watson                                     [cjw44@flatline.org.uk]