[Date Prev][Date Next] [Thread Prev][Thread Next] [Date Index] [Thread Index]

Re: PCI BIOS problems



Are you planning to reboot to make this work???

You can test anything using modprobe and/or insmod...
But the config files look good, so it should work (assuming you got the
jumpers right).

Ron

On Thu, 17 Feb 2000, Patrick Kirk wrote:

> So to make it work - please point out any obvious things I may have
> forgotten assuming I get the jumper settings right.
> 
> /etc/conf.modules
> alias eth0 ne
> alias eth1 ne
> options ne io=0x2c0,0x300 irq=10,11
> 
> /etc/modules
> #auto
> ne
> #ne2k-pci
> ip_alias
> ip_masq_quake
> ip_masq_raudio
> rarp
> 
> 
> ----- Original Message -----
> From: "Ron Rademaker" <ron@wep.tudelft.nl>
> To: "Patrick Kirk" <patrick@kirks.net>
> Cc: <debian-user@lists.debian.org>
> Sent: Thursday, February 17, 2000 3:16 PM
> Subject: Re: PCI BIOS problems
> 
> 
> > If the card can work on irq 11 and io 0x300 it should work because both
> > the irq as the io adress aren't taken. You should try it...
> >
> > Ron
> >
> > On Thu, 17 Feb 2000, Patrick Kirk wrote:
> >
> > > Would modprobe ne2k-pci io=0x300 irq=11 work when:
> > >
> > > cat /proc/io...
> > > 0000-001f : dma1
> > > 0020-003f : pic1
> > > 0040-005f : timer
> > > 0060-006f : keyboard
> > > 0070-007f : rtc
> > > 0080-008f : dma page reg
> > > 00a0-00bf : pic2
> > > 00c0-00df : dma2
> > > 00f0-00ff : npu
> > > 0170-0177 : ide1
> > > 01f0-01f7 : ide0
> > > 02c0-02df : NE2000
> > > 02f8-02ff : serial(set)
> > > 0376-0376 : ide1
> > > 03c0-03df : vga+
> > > 03f0-03f5 : floppy
> > > 03f6-03f6 : ide0
> > > 03f7-03f7 : floppy DIR
> > > 03f8-03ff : serial(set)
> > >
> > > cat /proc/interrupts
> > >  0:      16539   timer
> > >  1:          2   keyboard
> > >  2:          0   cascade
> > >  8:          2 + rtc
> > > 10:        305   NE2000
> > > 13:          1   math error
> > > 14:      14481 + ide0
> > > 15:          0 + ide1
> > >
> >
> >
> 


Reply to: