Re: PCI BIOS problems

["Patrick Kirk" <patrick@kirks.net>]

So to make it work - please point out any obvious things I may have
forgotten assuming I get the jumper settings right.

/etc/conf.modules
alias eth0 ne
alias eth1 ne
options ne io=0x2c0,0x300 irq=10,11

/etc/modules
#auto
ne
#ne2k-pci
ip_alias
ip_masq_quake
ip_masq_raudio
rarp


----- Original Message -----
From: "Ron Rademaker" <ron@wep.tudelft.nl>
To: "Patrick Kirk" <patrick@kirks.net>
Cc: <debian-user@lists.debian.org>
Sent: Thursday, February 17, 2000 3:16 PM
Subject: Re: PCI BIOS problems


> If the card can work on irq 11 and io 0x300 it should work because both
> the irq as the io adress aren't taken. You should try it...
>
> Ron
>
> On Thu, 17 Feb 2000, Patrick Kirk wrote:
>
> > Would modprobe ne2k-pci io=0x300 irq=11 work when:
> >
> > cat /proc/io...
> > 0000-001f : dma1
> > 0020-003f : pic1
> > 0040-005f : timer
> > 0060-006f : keyboard
> > 0070-007f : rtc
> > 0080-008f : dma page reg
> > 00a0-00bf : pic2
> > 00c0-00df : dma2
> > 00f0-00ff : npu
> > 0170-0177 : ide1
> > 01f0-01f7 : ide0
> > 02c0-02df : NE2000
> > 02f8-02ff : serial(set)
> > 0376-0376 : ide1
> > 03c0-03df : vga+
> > 03f0-03f5 : floppy
> > 03f6-03f6 : ide0
> > 03f7-03f7 : floppy DIR
> > 03f8-03ff : serial(set)
> >
> > cat /proc/interrupts
> >  0:      16539   timer
> >  1:          2   keyboard
> >  2:          0   cascade
> >  8:          2 + rtc
> > 10:        305   NE2000
> > 13:          1   math error
> > 14:      14481 + ide0
> > 15:          0 + ide1
> >
>
>