Re: Problem to burn cd with cdrecord
I have the same problem, however, it does not occur when the cdr is in the
drive for at least 4 hours before starting to write (its a bit warmer then,
so I guess its a problem with the laser not calibrating right when to cold).
since this also applies when using the drive with WinOnCD, it doesnt look
like a software-problem.
hth,
&rw
On Tue, 01 Feb 2000 15:48:32 GMT, "Markus Jaekel" writes:
>cdrecord: Eingabe-/Ausgabefehler. philips write_track: scsi sendcmd: retryable
> error
>CDB: E6 00 00 00 00 00 02 00 00 00
>status: 0x2 (CHECK CONDITION)
>Sense Bytes: 70 00 06 00 00 00 00 0A 00 00 00 00 29 00 00 00
>Sense Key: 0x6 Unit Attention, Segment 0
>Sense Code: 0x29 Qual 0x00 (power on, reset, or bus device reset occurred) Fru
> 0x0
--
-- +++ EUnet/KPNQwest@Exponet, 15.-17.2.'2k, Ebene02/Stand08 +++
----- ___ - Robert Waldner EUnet/AT tech staff
---- / / / ___ ____ _/_ -- <Waldner@Austria.EU.net> RW960-RIPE
--- /--- / / / / /___/ / --- ---EUnet EDV-DienstleistungsgesmbH---
-- /___ /___/ / / /___ /_ ---- Diefenbachgasse 35 A-1150 Wien
- ----- Tel: +43 1 89933 Fax: +43 1 89933 533
Reply to: