ACARD scsi help

[Jocke <jocke1s@tripnet.se>]

Hi all,

I installed a scsi card a week ago that I was told was a ADAPTEC 2904 card.
Well I couldn't get it to work and finally! *blush* checked the small paper
inside the plastic bag it came with and It is really an ACARD AEC-6710S

Ok I think and recompile (2.3.16) and adds acard lower level drive support.
Reboots and get the following message. (I have a HP 6200C scanner hooked to it)

aec6710x_detect:
ACARD AEC-671X PCI Ultra/W SCSI-3 Host Adapter: 0 IO:e400 IRQ:11.
ID: 0 HP C2270A 3828
ID: 7 Host Adapter
scsi0: ACARD AEC-6710/6712 PCI Ultra/W SCSI-3 Adapter Driver V1.0
scsi1: scsi host adapter emulation for IDE ATAPI devices
scsi: 2 hosts.

-snip-

SCSI bus is being reset for host0 channel 0.

...
Now the booting hangs.

So can any scsi gurus help me here or should I just return the card and
try with another card (maybe an Adaptec that I had first in mind) ?

Or can I get this to work ?

Any help/advice would be much appreciated.

Best Regards
Joakim Svensson