Re: slink install and libc6
MallarJ@aol.com writes:
> Thanks a bunch for the reply - but not sure if I understood you. I
> downloaded the libc6 package from slink - it gave me version
> 2.0.7.981211-2. The version in hamm is 2.0.7t. Are you saying I should
> use the hamm version instead of the slink version?
First off, let me apologize if I misunderstood you. I'm in digest mode, and
so I can't see mail threads. I didn't see the posts that started this
thread. Your message sounded like you were experiencing the same problem I
did. The big question is, are you are installing or upgrading to slink?
That's the assumption I made. Because I installed slink, and subsequently
had the same libc6/libc6-dev conflicts you write about. The root of the
problem was that the file /etc/apt/sources.list points at "stable", which
currently means hamm. Of course when slink leaves frozen it will be stable,
and so the circuit will be shorted.
If you change /etc/apt/sources.list to point at "frozen" (or "slink") and
then do an `apt-get update ; apt-get -f dist-upgrade`, you should be fine.
If you've got all hamm packages, then I don't know what's going on.
Good luck, and tell me/us what it was when you figure it out!
morgan
--
VVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVV
>> M o r g a n F l e t c h e r http://www.hahaha.org/morgan <<
>> Tibi gratias agimus quod nihil fumas. morgan@hahaha.org <<
Reply to: