eth0: bogus packet size with e2100
I'm trying to get a 486 with a Cabletron e21xx NIC in it to work.
After much time trying to figure out what I/O port the NIC is on, I
finally got it working at 0x380. It inserts the module and even
assigns an IP to it just fine, but I can't ping anywhere and I
continue to get kernel messages like these:
eth0: bogus packet size: 0, status 0x0, nxpg=0x0
I've tried moving it to a few different IRQ's, but that hasn't
helped.
Any ideas?
--
_____ _
| ____|(_) http://www.iit.edu/~jenseri
| _| | | Page me via ICQ at
| |___ | | http://wwp.mirabilis.com/19022931
|______/ | or by mailing 19022931@pager.mirabilis.com
|__/
Reply to: