RE: Jaz 1Gb on hamm dist
I wrote:
> Can you send me (and the list too) the output of "dmesg" and "fdisk -l"
> with the cartridge in the drive? This will help verify you are using the
> correct device.
On Sun, 6 Dec 1998, BOHICA wrote:
> ------------ dmesg -------------
>
> Vendor: iomega Model: jaz 1GB Rev: H.72
> Type: Direct-Access ANSI SCSI revision: 02
> Detected scsi removable disk sdc at scsi1, channel 0, id 5, lun 0
Ok, sdc is correct.
> ----------- fdisk -l ------------
>
> Disk /dev/sdc: 64 heads, 32 sectors, 1021 cylinders
> Units = cylinders of 2048 * 512 bytes
>
> Device Boot Begin Start End Blocks Id System
> /dev/sdc1 ? 937318 937477 1203315272218546+ 20 Unknown
> Partition 1 has different physical/logical beginnings (non-Linux?):
> phys=(356, 97, 46) logical=(937476, 3, 15)
> Partition 1 has different physical/logical endings:
> phys=(357, 116, 40) logical=(1203314, 30, 19)
> Partition 1 does not end on cylinder boundary:
> phys=(357, 116, 40) should be (357, 63, 32)
> /dev/sdc2 ? 648482 649505 912677269488144 6b Unknown
> Partition 2 has different physical/logical beginnings (non-Linux?):
> phys=(288, 110, 57) logical=(649504, 0, 11)
> Partition 2 has different physical/logical endings:
> phys=(269, 101, 57) logical=(912676, 1, 10)
> Partition 2 does not end on cylinder boundary:
> phys=(269, 101, 57) should be (269, 63, 32)
> /dev/sdc3 ? 262490 263179 945973699181456 53 Unknown
> Partition 3 has different physical/logical beginnings (non-Linux?):
> phys=(345, 32, 19) logical=(263178, 26, 16)
> Partition 3 has different physical/logical endings:
> phys=(324, 77, 19) logical=(945972, 51, 15)
> Partition 3 does not end on cylinder boundary:
> phys=(324, 77, 19) should be (324, 63, 32)
> /dev/sdc4 * 680024 680971 680981 10668+ 49 Unknown
> Partition 4 has different physical/logical beginnings (non-Linux?):
> phys=(87, 1, 0) logical=(680970, 34, 16)
> Partition 4 has different physical/logical endings:
> phys=(335, 78, 2) logical=(680980, 61, 8)
> Partition 4 does not end on cylinder boundary:
> phys=(335, 78, 2) should be (335, 63, 32)
>
> ---------- end -------------
Ack, looks like the standard dos/mac formatting trick. Try sdc4:
mount /dev/sdc4 /jaz
Or if it doesn't detect it:
mount -t vfat /dev/sdc4 /jaz
mount -t msdos /dev/sdc4 /jaz
You may also want to try sdc1 and sdc3 if 4 doesn't work.
HTH,
Brandon
+--- ---+
| Brandon Mitchell * bhmit1@mail.wm.edu * http://bhmit1.home.ml.org/ |
| Sometimes you have to release software with bugs. - MS Recruiter |
Reply to: