Error de LILO
Hola a todos.
Tengo un problema con LILO en una máquina. Me da el siguiente error al
ejecutarlo:
lennon:/etc# lilo
Added Linux *
Added old
Device 0x0300: Invalid partition table, 1st entry
3D address: 1/1/0 (63)
Linear address: 33/0/0 (32)
Este es el '/etc/lilo.conf':
boot = /dev/hda
root = /dev/hda6
install=/boot/boot.b
map=/boot/map
delay = 20
timeout = 500
compact
prompt
vga = normal
read-only
#
# Stmas / particiones
#
image = /vmlinuz
label = Linux
image = /vmlinuz.old
label = old
other = /dev/hda1
label = NT
table=/dev/hda
Esta es la organización de las particiones que tengo:
Disk /dev/hda: 255 heads, 63 sectors, 1653 cylinders
Units = cylinders of 16065 * 512 bytes
Device Boot Start End Blocks Id System
/dev/hda1 * 1 255 2047984 7 HPFS/NTFS
Partition 1 does not end on cylinder boundary:
phys=(1023, 63, 32) should be (1023, 254, 63)
/dev/hda2 766 1653 7132860 5 Extended
Partition 2 does not end on cylinder boundary:
phys=(1023, 33, 21) should be (1023, 254, 63)
/dev/hda3 255 752 3984624 82 Linux swap
/dev/hda5 766 777 96358+ 82 Linux swap
/dev/hda6 778 790 104391 83 Linux
/dev/hda7 791 802 96358+ 83 Linux
/dev/hda8 803 936 1076323+ 83 Linux
/dev/hda9 937 1179 1951866 83 Linux
/dev/hda10 1180 1301 979933+ 83 Linux
/dev/hda11 1302 1483 1461883+ 83 Linux
/dev/hda12 1484 1653 1365493+ 83 Linux
¿Qué puede ser?
Otra cosa, no hay manera de instalar un puñetero NT en la hda1. Es la
cosa más inútil que he visto en mi vida ;-) No es capaz (o noquiere)
instalarse en la partición hda1 sin tocar lo demás. ¿Por qué tiene que
meter las narices donde no le llaman? Joer ...!!
Un saludo y gracias:
JC
Reply to: