Frage input / output error
Hallo,
wenn ich bei einem Befehl wie
# dd if=/dev/sda1 | gzip -1 -v > sda1-2008-10-25-dd.gz
nach ein paar GB als Anwort von dd
dd: reading `/dev/sda1': Input/output error
bekomme, sollte ich dann eher früher als später die Platte tauschen?
(partimage gibt die gleiche Fehlermeldung aus)
smartctl sagt, die beiden letzten Fehler seien folgende gewesen:
Error 71 occurred at disk power-on lifetime: 4000 hours (166 days + 16
hours)
When the command that caused the error occurred, the device was active
or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 62 5a 2d e0 Error: UNC at LBA = 0x002d5a62 = 2972258
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
c8 00 05 62 5a 2d 00 00 02:31:41.665 READ DMA
27 00 00 00 00 00 00 00 02:31:41.664 READ NATIVE MAX ADDRESS EXT
ec 00 00 00 00 00 00 00 02:31:41.657 IDENTIFY DEVICE
ef 03 42 00 00 00 00 00 02:31:41.657 SET FEATURES [Set transfer
mode]
27 00 00 00 00 00 00 00 02:31:41.656 READ NATIVE MAX ADDRESS EXT
Error 70 occurred at disk power-on lifetime: 4000 hours (166 days + 16
hours)
When the command that caused the error occurred, the device was active
or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
01 51 00 62 5a 2d e0 Error: AMNF at LBA = 0x002d5a62 = 2972258
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
c8 00 05 62 5a 2d 00 00 02:31:39.107 READ DMA
27 00 00 00 00 00 00 00 02:31:39.107 READ NATIVE MAX ADDRESS EXT
ec 00 00 00 00 00 00 00 02:31:39.099 IDENTIFY DEVICE
ef 03 42 00 00 00 00 00 02:31:39.091 SET FEATURES [Set transfer
mode]
27 00 00 00 00 00 00 00 02:31:39.091 READ NATIVE MAX ADDRESS EXT
Danke,
Tilo
Reply to: