cdrecord bricht einfach ab
Hallo,
ich habe in letzte Zeit immer wieder Fehler beim Brennen von CD's (siehe
unten). An was kann das liegen? Ich verwende die Tevion Rohlinge von Aldi und
hatte mit diesen bisher noch keine Probleme. Liegt es wirklich am Rohling?
Was habt Ihr fuer Erfahrung mit Aldi Rohlinen? Mein Brenner ist ein
IDE-Plextor 8/4/32A. Betriebssystem Debian Woody.
Ich bin fuer jeden Tipp dankbar.
Gruss Rupert
Die CD wurde mit folgendem Befehl gebrannt (Audio-CD):
cdrecord dev=0,1,0 fs=16384k -v -useinfo speed=8 -dao -pad -audio $(/bin/ls
*.wav)
Ausgabe:
pregap1: -1
Cdrecord 1.10 (i686-pc-linux-gnu) Copyright (C) 1995-2001 Jörg Schilling
TOC Type: 0 = CD-DA
scsidev: '0,1,0'
scsibus: 0 target: 1 lun: 0
Linux sg driver version: 3.1.22
Using libscg version 'schily-0.5'
atapi: 1
Device type : Removable CD-ROM
Version : 0
Response Format: 1
Vendor_info : 'PLEXTOR '
Identifikation : 'CD-R PX-W8432T'
Revision : '1.09'
Device seems to be: Generic mmc CD-RW.
Using generic SCSI-3/mmc CD-R driver (mmc_cdr).
Driver flags : SWABAUDIO
Drive buf size : 4194304 = 4096 KB
FIFO size : 16777216 = 16384 KB
Track 01: audio 55 MB (05:32.48) no preemp pad
Track 02: audio 25 MB (02:31.74) no preemp pad
Track 03: audio 53 MB (05:16.47) no preemp pad
Track 04: audio 53 MB (05:17.59) no preemp pad
Track 05: audio 33 MB (03:16.72) no preemp pad
Track 06: audio 56 MB (05:38.67) no preemp pad
Track 07: audio 14 MB (01:25.55) no preemp pad
Track 08: audio 48 MB (04:50.27) no preemp pad
Track 09: audio 48 MB (04:48.67) no preemp pad
Track 10: audio 42 MB (04:13.10) no preemp pad
Track 11: audio 66 MB (06:33.48) no preemp pad
Total size: 498 MB (49:24.85) = 222364 sectors
Lout start: 499 MB (49:26/64) = 222364 sectors
Current Secsize: 2048
ATIP info from disk:
Indicated writing power: 4
Is not unrestricted
Is not erasable
Disk sub type: Medium Type A, low Beta category (A-) (2)
ATIP start of lead in: -12508 (97:15/17)
ATIP start of lead out: 359845 (79:59/70)
Disk type: Short strategy type (Phthalocyanine or similar)
Manuf. index: 22
Manufacturer: Ritek Co.
Blocks total: 359845 Blocks current: 359845 Blocks remaining: 137481
Starting to write CD/DVD at speed 8 in write mode for single session.
Last chance to quit, starting real write in 0 seconds. Operation starts.
Waiting for reader process to fill input buffer ... input buffer ready.
Performing OPC...
Sending CUE sheet...
Writing pregap for track 1 at -150
Starting new track at sector: 0
Track 01: 55 of 55 MB written (fifo 100%).
WARNING: padding up to secsize.
Track 01: Total bytes read/written: 58650624/58651824 (24937 sectors).
Starting new track at sector: 24937
Track 02: 25 of 25 MB written (fifo 100%).
WARNING: padding up to secsize.
Track 02: Total bytes read/written: 26767872/26768112 (11381 sectors).
Starting new track at sector: 36318
Track 03: 53 of 53 MB written (fifo 100%).
WARNING: padding up to secsize.
Track 03: Total bytes read/written: 55825920/55827072 (23736 sectors).
Starting new track at sector: 60054
Track 04: 16 of 53 MB written (fifo 100%).cdrecord: Input/output error.
write_g1: scsi sendcmd: no error
CDB: 2A 00 00 01 06 BF 00 00 1B 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: F0 00 03 00 01 07 55 0A 00 00 00 00 0C 07 00 00
Sense Key: 0x3 Medium Error, Segment 0
Sense Code: 0x0C Qual 0x07 (write error - recovery needed) Fru 0x0
Sense flags: Blk 67413 (valid)
cmd finished after 0.014s timeout 200s
write track data: error after 16955568 bytes
Sense Bytes: 70 00 00 00 00 00 00 0A 00 00 00 00 00 00 00 00 00 00
Writing time: 140.643s
Fixating...
cdrecord: Input/output error. flush cache: scsi sendcmd: no error
CDB: 35 00 00 00 00 00 00 00 00 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: 70 00 05 00 00 00 00 0A 00 00 00 00 2C 00 00 00
Sense Key: 0x5 Illegal Request, Segment 0
Sense Code: 0x2C Qual 0x00 (command sequence error) Fru 0x0
Sense flags: Blk 0 (not valid)
cmd finished after 0.000s timeout 200s
Trouble flushing the cache
Fixating time: 0.001s
cdrecord: fifo had 2748 puts and 2494 gets.
cdrecord: fifo was 0 times empty and 2056 times full, min fill was 99%.
Reply to: