pas de pcmcia cardbus support
Bonjour,
J'essaie d'utiliser les modules ralink du noyau 2.6.26
j'ai une carte pcmcia avec puce ralink.
Cependant à l'introduction de la carte syslog écrit:
kernel: cs: pcmcia_socket0: cardbus cards are not supported.
mon lspci:
00:00.0 Host bridge: Transmeta Corporation LongRun Northbridge (rev 01)
00:00.1 RAM memory: Transmeta Corporation SDRAM controller
00:00.2 RAM memory: Transmeta Corporation BIOS scratchpad
00:02.0 USB Controller: ALi Corporation USB 1.1 Controller (rev 03)
00:04.0 Multimedia audio controller: ALi Corporation M5451 PCI AC-Link
Controller Audio Device (rev 01)
00:06.0 Bridge: ALi Corporation M7101 Power Management Controller [PMU]
00:07.0 ISA bridge: ALi Corporation M1533/M1535/M1543 PCI to ISA Bridge
[Aladdin IV/V/V+]
00:0c.0 CardBus bridge: Texas Instruments PCI1410 PC card Cardbus
Controller (rev 01)
00:0f.0 IDE interface: ALi Corporation M5229 IDE (rev c3)
00:12.0 Ethernet controller: Realtek Semiconductor Co., Ltd.
RTL-8139/8139C/8139C+ (rev 10)
00:13.0 FireWire (IEEE 1394): Texas Instruments TSB43AB21 IEEE-1394a-2000
Controller (PHY/Link)
00:14.0 VGA compatible controller: ATI Technologies Inc Rage Mobility P/M
(rev 64)
J'ai pourtant le module pcmcia_core:
lsmod |grep pcmcia
pcmcia 29132 -
pcmcia_core 31052 -
dmesg:
Yenta: CardBus bridge found at 0000:00:0c.0 [10cf:10c6]
Yenta: adjusting diagnostic: 41 -> 61
Yenta: Using CSCINT to route CSC interrupts to PCI
Yenta: Routing CardBus interrupts to PCI
Yenta TI: socket 0000:00:0c.0, mfunc 0x00c61d22, devctl 0x46
Yenta TI: socket 0000:00:0c.0 probing PCI interrupt failed, trying to fix
Yenta TI: socket 0000:00:0c.0 falling back to parallel PCI interrupts
Yenta TI: socket 0000:00:0c.0 no PCI interrupts. Fish. Please report.
Yenta: no PCI IRQ, CardBus support disabled for this socket.
Yenta: check your BIOS CardBus, BIOS IRQ or ACPI settings.
Yenta: ISA IRQ mask 0x04f8, PCI irq 0
Quelqu´un a t'il une idée?
Georges
Reply to: