[Date Prev][Date Next] [Thread Prev][Thread Next] [Date Index] [Thread Index]

Re: [ReiserFS] Partition pourrie après passage sous Windows



Le Fri, 24 Dec 2004 19:40:08 +0100, Glennie Vignarajah a écrit :

> Annabelle D. a écrit: 
> 
>> Bonjour la liste,
> 
> Salut,
> 
>> Voilà, j'ai installé récemment un nouveau disk dur dans un rack
>> IDE. Je l'ai partagé en 2 partitions : hdc1 = Linux/ReiserFS et
>> hdc2= Windows/FAT32. 
> 
>> Or je ne sais 
>> pas comment récupérer cette info ! La partition étant la première,
>> je met 0 ??

cat check_20041218.log
Zero bit found in on-disk bitmap after the last valid bit.
bad_internal: vpf-10330: block 64971, item 56: The internal item points to the not legal block (7077888)
 the problem in the internal node occured (64971), whole subtree is skipped
vpf-10640: The on-disk and the correct bitmaps differs.


>> Lorsque je lance un cfdisk sur /dev/hdc il me fait une erreur dans
>> la table des partitions donc je ne peux pas voir les partitions.
>  
>  Quel est le message d'erreur exacte?

le cfdisk ne me fait plus d'erreur !? (entre temps j'ai changé de carte
mère et donc recompilé le noyau)
mais je ne peux toujours pas monter la partition :'(

reiserfsck --check --logfile check_20041231.log /dev/hdc1
reiserfsck 3.6.19 (2003 www.namesys.com)

*************************************************************
** If you are using the latest reiserfsprogs and  it fails **
** please  email bug reports to reiserfs-list@namesys.com, **
** providing  as  much  information  as  possible --  your **
** hardware,  kernel,  patches,  settings,  all reiserfsck **
** messages  (including version),  the reiserfsck logfile, **
** check  the  syslog file  for  any  related information. **
** If you would like advice on using this program, support **
** is available  for $25 at  www.namesys.com/support.html. **
*************************************************************

Will read-only check consistency of the filesystem on /dev/hdc1
Will put log info to 'check_20041231.log'

Do you want to run this program?[N/Yes] (note need to type Yes if you do):Yes

reiserfs_open: the reiserfs superblock cannot be found on /dev/hdc1.
Failed to open the filesystem.

If the partition table has not been changed, and the partition is
valid  and  it really  contains  a reiserfs  partition,  then the
superblock  is corrupted and you need to run this utility with
--rebuild-sb.

> Essayez avec sfdisk --list /dev/hdc !

sfdisk --list /dev/hdc

Disque /dev/hdc: 20023 cylindres, 255 têtes, 63 secteurs/piste
Unités= cylindres de 8225280 octets, blocs de 1024 octets, décompte à partir de 0

   Périph Amor Début     Fin   #cyls    #blocs    Id  Système
/dev/hdc1          0+   9725    9726-  78124063+  83  Linux
/dev/hdc2       9726   20022   10297   82710652+   c  W95 FAT32 (LBA)
/dev/hdc3          0       -       0          0    0  Vide
/dev/hdc4          0       -       0          0    0  Vide


Alors je tente un reiserfsck --rebuild-sb /dev/hdc1 ?

reiserfsck --rebuild-sb --logfile rebuild_sb_20041231.log /dev/hdc1
reiserfsck 3.6.19 (2003 www.namesys.com)

*************************************************************
** If you are using the latest reiserfsprogs and  it fails **
** please  email bug reports to reiserfs-list@namesys.com, **
** providing  as  much  information  as  possible --  your **
** hardware,  kernel,  patches,  settings,  all reiserfsck **
** messages  (including version),  the reiserfsck logfile, **
** check  the  syslog file  for  any  related information. **
** If you would like advice on using this program, support **
** is available  for $25 at  www.namesys.com/support.html. **
*************************************************************

Will check superblock and rebuild it if needed
Will put log info to 'rebuild_sb_20041231.log'

Do you want to run this program?[N/Yes] (note need to type Yes if you do):Yes

reiserfs_open: the reiserfs superblock cannot be found on /dev/hdc1.

what the version of ReiserFS do you use[1-4]
        (1)   3.6.x
        (2) >=3.5.9 (introduced in the middle of 1999) (if you use linux 2.2, choose this one)
        (3) < 3.5.9 converted to new format (don't choose if unsure)
        (4) < 3.5.9 (this is very old format, don't choose if unsure)
        (X)   exit
1

Enter block size [4096]:


là je sais pas koi mettre :'(

Merci pour votre aide :)


PS: Désolée de reprendre ce thread si tard mais entre temps j'ai
accouché (le 25 déc !!) alors j'ai pas pu m'occuper de mon pc que je
viens de rallumer aujourd'hui, mon frère ayant changé la carte mère
entre temps ;)

-- 
@++

Annabelle 



Reply to: