Re: [Debian]:scsi-platte wechselt die Position bei wechselplatten...
On Mon, Dec 06, 1999 at 10:34:26PM +0100, Andreas Schuldei wrote:
> Wenn ich eine ide-platte als Wechselplatte in meinen Rechner stecke, der sonst
> noch eine scsi-Platte enthaelt, von der gebootet werden soll, streikt lilo.
>
> Lilo sagt dann, das device waere illegal (Fehlercode 01). Mit hdb drin ist sda
> die zweite platte, ohne halt die erste. entspechend kommt lilo durcheinander.
>
> Was ist zu tun? Wer hat solche konfiguratinen am laufen? wie hast du das
> gemacht?
eine installation wie deine hab ich zwar nicht, aber /vielleicht/ hilft dir
die 'map-drive' option von lilo weiter. hier ein ausschnitt aus der
Manual.txt.gz :
<snip>
MAP-DRIVE=<bios_device_code> Instructs chain.b to installs a resident
driver that re-maps the floppy or hard disk drives. This way, one can
boot any operating system from a hard disk different from the first one,
as long as that operating system uses _only_ the BIOS to access that
hard disk.* This is known to work for PC/MS-DOS.
* So you should be very suspicious if the operating system
requires any specific configuration or even drivers to use the
disk it is booted from. Since there is a general trend to use
optimized drivers to fully exploit the hardware capabilities
(e.g. non-blocking disk access), booting systems from the second
disk may become increasingly difficult.
MAP-DRIVE is followed by the variable
TO=<bios_device_code> which specifies the drive that should
effectively be accessed instead of the original one. The list
of mappings is only searched until the first match is found.
It is therefore possible to "swap" drives, see the second
example below.
<snip>
Examples:
other = /dev/hda2
label = dos
table = /dev/hda
other = /dev/hdb2
label = os2
loader = /boot/os2_d.b
map-drive = 0x80
to = 0x81
map-drive = 0x81
to = 0x80
<snip>
vielleicht hilft's :-/
--
chiba:~# for BILL in 6 6 6; do nuke; done
It took 124 years to destroy the world.
It took 42 years to destroy the world.
You win! 500 years without destruction!
------------------------------------------------
Um sich aus der Liste auszutragen schicken Sie
bitte eine E-Mail an majordomo@jfl.de die im Body
"unsubscribe debian-user-de <deine emailadresse>"
enthaelt.
Bei Problemen bitte eine Mail an: Jan.Otto@jfl.de
------------------------------------------------
Anzahl der eingetragenen Mitglieder: 774
Reply to: