Re: Broadcom tg3 on Sunfire V210 problem
On Mon, Apr 16, 2007 at 03:41:22PM +0100, Luís Pratas wrote:
> I can normally boot the system but I can't get the network interfaces
> working.
>
> My kernel is 2.6.18-4-sparc64-smp
>
> # dmesg output
> # dmesg | grep eth0
>
> eth0: Tigon3 [partno(none) rev 2003 PHY(5704)] (PCI:66MHz:64-bit) 10/100/1000BaseT Ethernet 00:03:ba:8d:7b:c3
> eth0: RXcsums[1] LinkChgREG[0] MIirq[0] ASF[0] Split[0] WireSpeed[1] TSOcap[1]
> eth0: dma_rwctrl[763f0000] dma_mask[32-bit]
> tg3: eth0: No firmware running.
> ADDRCONF(NETDEV_UP): eth0: link is not ready
The firmware mention is irrelevant, you get that even with working cards.
On a V240, I see the following on 2.6.18-4-sparc64 in the install system:
tg3: eth%d: Cannot get nvarm lock, tg3_nvram_init failed.
eth0: Tigon3 [partno(none) rev 2003 PHY(5704)] (PCI:66MHz:64-bit) 10/100/1000BaseT Ethernet 00:03:ba:xx:xx:xx
eth0: RXcsums[1] LinkChgREG[0] MIirq[0] ASF[0] Split[0] WireSpeed[1] TSOcap[1]
eth0: dma_rwctrl[763f0000] dma_mask[32-bit]
tg3: eth0: No firmware running.
Maybe your problem is as simple as mine - the physical layout of those
cards doesn't match the numbering of the devices? I've got four, and
IIRC eth2 is the first one :)
--
2. That which causes joy or happiness.
Reply to: