[Date Prev][Date Next] [Thread Prev][Thread Next] [Date Index] [Thread Index]

Re: machine hangs after high disk IO load



Hi Noel,

On Mon, 16 Feb 2004, Noèl Köthe wrote:

> Hello,
>
> scsi : aborting command due to timeout : pid 6490, scsi0, channel 0, id
> 3, lun 0 Write (10) 0
> esp0: Aborting command
> esp0: dumping state
> esp0: dma -- cond_reg<b2bf8810> addr<00000000>
> esp0: SW [sreg<10> sstep<04> ireg<20>]
> esp0: HW reread [sreg<10> sstep<cc> ireg<00>]
>
> esp0: disconnected [tgt<03> lun<00> pphase<FREEING> cphase<FREEING>]
> SCSI host 0 abort (pid 6490) timed out - resetting
> SCSI bus is being reset for host 0 channel 0.
> esp0: Resetting scsi bus
> esp0: SCSI bus reset interrupt
> esp0: SCSI bus reset interrupt
> esp0: DMA error b2bf8a03
> esp0: Resetting scsi bus
> esp0: SCSI bus reset interrupt
> esp0: Warning, live target 3 not responding to selection.

Last time i saw similar messages was the scsi controller but i would also
check the if cable and terminations are ok.

Fabio

-- 
<user> fajita: step one
<fajita> Whatever the problem, step one is always to look in the error log.
<user> fajita: step two
<fajita> When in danger or in doubt, step two is to scream and shout.



Reply to: