Re: Debian 3.0 on a Netra T1
Thu 01 May 2003 à 10:27:17PM -0400, Ben Collins a écrit :
> After you cancel out of the hung format, can you then go down to
> "Execute shell" in the install menu and do a "dmesg" from the shell to
> see if there was any kernel output?
A little more information.
I use to have to disks simultaneously in the system (sda and sdb).
I tried with each of the disk alone.
In the boot phase, I am getting
**********************************************************************
SCSI subsystem driver Revision: 1.00
sym.2.8.0: setting PCI_COMMAND_INVALIDATE.
sym.2.8.1: setting PCI_COMMAND_INVALIDATE.
sym0: <896> rev 0x7 on pci bus 2 device 8 function 0 irq 4,7e0
sym0: using 64 bit DMA addressing
sym0: No NVRAM, ID 7, Fast-40, LVD, parity checking
sym0: SCSI BUS has been reset.
sym1: <896> rev 0x7 on pci bus 2 device 8 function 1 irq 4,7e0
sym1: using 64 bit DMA addressing
sym1: No NVRAM, ID 7, Fast-40, LVD, parity checking
sym1: SCSI BUS has been reset.
scsi0 : sym-2.1.17a
scsi1 : sym-2.1.17a
Vendor: SEAGATE Model: ST336607LSUN36G Rev: 0207
Type: Direct-Access ANSI SCSI revision: 03
sym0:0:0: tagged command queuing enabled, command queue depth 16.
Attached scsi disk sda at scsi0, channel 0, id 0, lun 0
sym0:0: FAST-40 WIDE SCSI 80.0 MB/s ST (25.0 ns, offset 31)
SCSI device sda: 71132959 512-byte hdwr sectors (36420 MB)
Partition check:
sda: sda1 sda2 sda3
**********************************************************************
With the setup with a single disk, I get a
"The filesystem was not created."
and during one of the tests it sent me back to the list of choices.
I picked "execute a shell" as you advised, dmesg gives :
le ECC Error AFSR[188300000] AFAR[000000000e88e000] UDBL[2ac] UDBH[0]
CPU[0]: Correctable ECC Error AFSR[188300000] AFAR[000000000e88e000]
UDBL[2ac] UDBH[0]
CPU[0]: Correctable ECC Error AFSR[188300000] AFAR[000000000e88e000]
UDBL[2ac] UDBH[0]
CPU[0]: Correctable ECC Error AFSR[188300000] AFAR[000000000e88e000]
UDBL[2ac] UDBH[0]
CPU[0]: Correctable ECC Error AFSR[188300000] AFAR[000000000e88e000]
UDBL[2ac] UDBH[0]
CPU[0]: Correctable ECC Error AFSR[188300000] AFAR[000000000e88e000]
UDBL[2ac] UDBH[0]
CPU[0]: Correctable ECC Error AFSR[188300000] AFAR[000000000e88e000]
UDBL[2ac] UDBH[0]
CPU[0]: Correctable ECC Error AFSR[188300000] AFAR[000000000e88e000]
UDBL[2ac] UDBH[0]
CPU[0]: Correctable ECC Error AFSR[188300000] AFAR[000000000e88e000]
UDBL[2ac] UDBH[0]
CPU[0]: Correctable ECC Error AFSR[188300000] AFAR[000000000e88e000]
UDBL[2ac] UDBH[0]
CPU[0]: Correctable ECC Error AFSR[188300000] AFAR[000000000e88e000]
UDBL[2ac] UDBH[0]
Adding Swap: 51184k swap-space (priority -1)
CPU[0]: Correctable ECC Error AFSR[188300000] AFAR[000000000e88e000]
UDBL[2ac] UDBH[0]
CPU[0]: Correctable ECC Error AFSR[188300000] AFAR[000000000e88e000]
UDBL[2ac] UDBH[0]
CPU[0]: Correctable ECC Error AFSR[188300000] AFAR[000000000e88e000]
UDBL[2ac] UDBH[0]
CPU[0]: Correctable ECC Error AFSR[188300000] AFAR[000000000e88e000]
UDBL[2ac] UDBH[0]
CPU[0]: Correctable ECC Error AFSR[188300000] AFAR[000000000e88e000]
UDBL[2ac] UDBH[0]
CPU[0]: Correctable ECC Error AFSR[188300000] AFAR[000000000e88e000]
UDBL[2ac] UDBH[0]
CPU[0]: Correctable ECC Error AFSR[188300000] AFAR[000000000e88e000]
UDBL[2ac] UDBH[0]
CPU[0]: Correctable ECC Error AFSR[188300000] AFAR[000000000e88e000]
UDBL[2ac] UDBH[0]
Unable to handle kernel paging request at virtual address
0000000000210000
tsk->{mm,active_mm}->context = 0000000000000435
tsk->{mm,active_mm}->pgd = fffff8000fa65000
\|/ ____ \|/
"@'/ .. \`@"
/_| \__/ |_\
\__U_/
mkfs.ext2(64): Oops
TSTATE: 00000000f0009606 TPC: 00000000005dc334 TNPC: 00000000005dc338 Y:
00378000 Not tainted
g0: fffff8000effdf65 g1: 0000000000000000 g2: 0000000000000008 g3:
0000000000000000
g4: fffff80000000000 g5: 0000000000000011 g6: fffff8000f8cc000 g7:
00000000005dc000
o0: 0000000000210000 o1: 0000000000000030 o2: 0000000000000080 o3:
0000000000000000
o4: 0000000000000080 o5: 0000000000000000 sp: fffff8000f8cee61 ret_pc:
000000000047a714
l0: 0000000000000000 l1: 0000004411009605 l2: 00000000005e7ae8 l3:
0000000000000400
l4: 0000000000000000 l5: 0000000000000000 l6: 0000000000000000 l7:
0000000000000008
i0: 0000000000210000 i1: fffff8000fdff408 i2: 0000000000000001 i3:
000000000047a700
i4: 0000000000000000 i5: 00000000006f9400 i6: fffff8000f8cef21 i7:
000000000045d348
Caller[000000000045d558]
Caller[00000000004679bc]
Caller[0000000000467a78]
Caller[0000000000467cf4]
Caller[0000000000468030]
Caller[000000000046893c]
Caller[000000000046beb4]
Caller[000000000045a088]
Caller[0000000000465250]
Caller[0000000000410af4]
Caller[000000007003b2c4]
Instruction DUMP: 02c2800a 9da00942 02400006 <c1ba2000> 80a2a080
02400003 c1ba2040 c1ba2080 02c2c009
SABRE0: Correctable Error, primary error type[DMA Read]
SABRE0: syndrome[83] bytemask[00ff] dword_offset[0] was_block(1)
SABRE0: CE AFAR [000000000e88e000]
SABRE0: CE Secondary errors [(DMA Read)]
SABRE0: Uncorrectable Error, primary error type[DMA Read]
SABRE0: bytemask[00ff] dword_offset[0] was_block(1)
SABRE0: UE AFAR [000000000e88e000]
SABRE0: UE Secondary errors [(none)]
sym0:0: ERROR (a0:0) (0-20-0) (1f/9f/0) @ (scripta b00:1000dfd8).
sym0: script cmd = 88080000
sym0: regdump: da 10 c0 9f 47 1f 00 00 ca 00 80 20 80 01 08 09 00 b8 fd
c3 08 00 00 00.
sym0: PCI STATUS = 0x1000
sym0: SCSI BUS reset detected.
sym0: SCSI BUS has been reset.
SABRE0: Correctable Error, primary error type[DMA Read]
SABRE0: syndrome[83] bytemask[00ff] dword_offset[0] was_block(1)
SABRE0: CE AFAR [000000000e88e000]
SABRE0: CE Secondary errors [(DMA Read)]
SABRE0: Uncorrectable Error, primary error type[DMA Read]
SABRE0: bytemask[00ff] dword_offset[0] was_block(1)
SABRE0: UE AFAR [000000000e88e000]
SABRE0: UE Secondary errors [(none)]
sym0:0: ERROR (a0:0) (0-20-0) (1f/9f/0) @ (scripta b00:1000dfd8).
sym0: script cmd = 88080000
sym0: regdump: da 10 c0 9f 47 1f 00 00 4e 00 80 20 80 01 08 09 00 d8 fd
c3 08 00 00 00.
sym0: PCI STATUS = 0x1000
sym0: SCSI BUS reset detected.
sym0: SCSI BUS has been reset.
SABRE0: Correctable Error, primary error type[DMA Read]
SABRE0: syndrome[83] bytemask[00ff] dword_offset[0] was_block(1)
SABRE0: CE AFAR [000000000e88e000]
SABRE0: CE Secondary errors [(DMA Read)]
SABRE0: Uncorrectable Error, primary error type[DMA Read]
SABRE0: bytemask[00ff] dword_offset[0] was_block(1)
SABRE0: UE AFAR [000000000e88e000]
SABRE0: UE Secondary errors [(none)]
sym0:0: ERROR (a0:0) (0-20-0) (1f/9f/0) @ (scripta b00:1000dfd8).
sym0: script cmd = 88080000
sym0: regdump: da 10 c0 9f 47 1f 00 00 de 00 80 20 80 01 08 09 00 d0 fd
c3 08 00 00 00.
sym0: PCI STATUS = 0x1000
sym0: SCSI BUS reset detected.
sym0: SCSI BUS has been reset.
SABRE0: Correctable Error, primary error type[DMA Read]
SABRE0: syndrome[83] bytemask[00ff] dword_offset[0] was_block(1)
SABRE0: CE AFAR [000000000e88e000]
SABRE0: CE Secondary errors [(DMA Read)]
SABRE0: Uncorrectable Error, primary error type[DMA Read]
SABRE0: bytemask[00ff] dword_offset[0] was_block(1)
SABRE0: UE AFAR [000000000e88e000]
SABRE0: UE Secondary errors [(none)]
sym0:0: ERROR (a0:0) (0-20-0) (1f/9f/0) @ (scripta b00:1000dfd8).
sym0: script cmd = 88080000
sym0: regdump: da 10 c0 9f 47 1f 00 00 82 00 80 20 80 01 08 09 00 f0 fd
c3 08 00 00 00.
sym0: PCI STATUS = 0x1000
sym0: SCSI BUS reset detected.
sym0: SCSI BUS has been reset.
SABRE0: Correctable Error, primary error type[DMA Read]
SABRE0: syndrome[83] bytemask[00ff] dword_offset[0] was_block(1)
SABRE0: CE AFAR [000000000e88e000]
SABRE0: CE Secondary errors [(DMA Read)]
SABRE0: Uncorrectable Error, primary error type[DMA Read]
SABRE0: bytemask[00ff] dword_offset[0] was_block(1)
SABRE0: UE AFAR [000000000e88e000]
SABRE0: UE Secondary errors [(none)]
sym0:0: ERROR (a0:0) (0-20-0) (1f/9f/0) @ (scripta b00:1000dfd8).
sym0: script cmd = 88080000
sym0: regdump: da 10 c0 9f 47 1f 00 00 1a 00 80 20 80 01 00 09 00 80 fd
c3 08 00 00 00.
sym0: PCI STATUS = 0x1000
sym0: SCSI BUS reset detected.
sym0: SCSI BUS has been reset.
Doesn't look too good, does it?
CPU issue?
--
Guillaume Tamboise
First they ignore you, then they laugh at you, then they fight you,
then you win." -- Gandhi
Reply to: