Re: DHCP with happy meal and/or lance
Le mer 25/09/2002 à 15:15, Ben Collins a écrit :
> > The (strange) problem is:
> > 1?) when i don't put the 2nd card in my sparc, all works fine, i can
> > dhcp on eth0
> > 2?) when i put the second one, dhcp doesn't work ( eth0 doesn't work:
> > linux says "cable problem" ie twisted pairs RJ45 cable). But when i go
> > into openprom i can self-test the both ethernet (connected one after one
> > to the cable modem), and that's seem good ( i see good ethernet pacquet
> > (a dot) and none bad eth pacquet (a X)).
>
> Are you sure that eth0 really is the card you think it is? Linux does
> not order the same as the OBP does.
I'm sure, unfortunately i havent the log here (i'm at work).
>
> If you want to force one card to be eth0, then compile the driver for
> that card into the kernel, and compile the other ethernet driver as a
> module and load it at boot.
I will make test tonight... thanks.
is it a bad idea "ether=.." parameters?
Another thing:
I've made test with ethtool (good stuff ;) and eth0 seem fine (i can
read/modify its conf) but eth1 doesn't work ( i had a message like it is
not supported by device!)...
that's why i've seen that dhclient put the card in speed=10 autoneg no,
etc...
>
> --
> Debian - http://www.debian.org/
> Linux 1394 - http://www.linux1394.org/
> Subversion - http://subversion.tigris.org/
> Deqo - http://www.deqo.com/
>
>
> --
> To UNSUBSCRIBE, email to debian-sparc-request@lists.debian.org
> with a subject of "unsubscribe". Trouble? Contact listmaster@lists.debian.org
>
>
Reply to: