Re: problem with dhcp on Sun SS20 with 2 nic
> On Mon, Jul 01, 2002 at 02:44:34PM +0200, chevalier francis wrote:
> | Hi
> | I am newbies on Debian and i installed a potato on a Sun SS20 with 2
nic.I bring 1 nic (eth1) for my personal network and another nic (eth0) for
connecting my cable modem .
> | But i have some problem with dhcp client :
> | if i make /proc/net/dev i see the 3 nic (l0 ,eth0 and eth1)
> | if i make dmesg i see that eth0 and eth1are seen at boot
> | but if i make ifconfig ,i only see eth1and l0
> | In :etc:network/interfaces ,eth1 is static (fixed IP for the local
network) and eth0 is dhcp but when i make /etc/init.d/networking restart i
have the following message :dhcpcd not running .
> | some help ?
> | Thanks
> | Francis
>
> Hello ,
>
> I had configured the same configuration SS20+1 NIC ,
> with debian woody ( but without dhcp ) .
>
> My eth0 & eth1 had the SAME HW MAC adress .
> My HW MAC is a mixt with host id .
>
> So I can not put on the same ethernet network .
>
> --
>
On my SS20 i have too the same MAC adress (who is a part of host id who is
itself in the boot prom ,i think) but the 2 nic get well if i connect they
separtely on my local network and if i make an ifconfig with the good IP
adress .
So Erwan ,what is the result of your ifconfig ?
On my system ,i dont see the nic who is on dhcp.
Francis
____________________________________________________________
--
To UNSUBSCRIBE, email to debian-sparc-request@lists.debian.org
with a subject of "unsubscribe". Trouble? Contact listmaster@lists.debian.org
Reply to: