[Date Prev][Date Next] [Thread Prev][Thread Next] [Date Index] [Thread Index]

Re: installing debian on sparc

What parameters do you have to enter? I have several Sparc20's and Sparc10's
I'd like to run on debian.

Steve Carter

----- Original Message -----
From: "Kurt D. Starsinic" <kstar@cpan.org>
To: "Mario Zuppini" <tribune@cybersol.com.au>
Cc: <debian-sparc@lists.debian.org>
Sent: Saturday, January 06, 2001 10:57 AM
Subject: Re: installing debian on sparc

> On Fri, Jan 05, 2001 at 05:50:52PM +1000, Mario Zuppini wrote:
> > Hey people, need urgent help
> >
> > trying to install debian on 3 of our sparcserver10's here, and the
installation part is fine
> > but when it goes to reboot, it wont boot, comes up with error at a
certain byte of the hdd
> >
> > but if i change the hard disk parititoning byte changes, leading me to
beleive it was a hard drive partitioning error.
> > So i've tried every known combination to man in my partitioning.
> >
> > Has anyone had any success at all installing debian (any versions) onto
a sparcserver 10 ?
>     I've installed woody on a SPARCserver 20 (several times), and I have
> enter parameters at the SILO prompt every time I boot it.  Other than
> it runs fine, but no matter how small the drive or how I partition it, I
> to specify the SILO options at the prompt.
>     - Kurt
> --
> To UNSUBSCRIBE, email to debian-sparc-request@lists.debian.org
> with a subject of "unsubscribe". Trouble? Contact

Reply to: