X Server for Ultra 10 with Creator 3D ??
I am new to Debian Sparc and only have experience on the Intel x86
platform with Debian. The install went fine using rarp on my Ultra 10.
But only with the newest version, discovered here in the news list !!
All packages installed just fine, but now I am trying to get XFree
running. I still do not know, which X Server to run, but after some
trials and internet searches I think I have to use the Mach 64 Server
?!!??
I have two framebuffers in my UltraSparc 10, the standard one and the
Creator 3D. It seems to be a ATI Rage Prog Mach 64 based graphics card.
So I tried the Mach64 Server and get the following message:
Fatal Server Error:
InitiIOAddresses: Sparse IO requested, can't handle on SPARC
The rest of the startup (X -probeonly) is:
---------------------------------------
XFree86 Version 3.3.6 / X Window System
(protocol Version 11, revision 0, vendor release 6300)
Release Date: January 8 2000
If the server is older than 6-12 months, or if your card is
newer
than the above date, look for a newer version before reporting
problems. (see http://www.XFree86.Org/FAQ)
Operating System: Linux 2.2.15-pre14 sparc64 [ELF]
Configured drivers:
Mach64: accelerated server for ATI Mach64 graphics adaptors
(Patchlevel 0)
(using VT number 7)
XF86Config: /usr/X11R6/lib/X11/XF86Config
(**) stands for supplied, (--) stands for probed/default values
(**) XKB: model: "sun"
(**) XKB: keycodes: "sun(type5)"
(**) Mouse: type: sun, device: /dev/mouse, buttons: 3
(**) Mach64: Graphics device ID: "My Video Card"
(**) Mach64: Monitor ID: "Sony Multiscan 17seII"
(--) Mach64: Mode "1280x1024x76" needs hsync freq of 81.13 kHz. Deleted.
(**) FontPath set to
"/usr/lib/X11/fonts/misc/:unscaled,/usr/lib/X11/fonts/cyrillic/:unscaled,/usr/l
ib/X11/fonts/100dpi/:unscaled,/usr/lib/X11/fonts/75dpi/:unscaled,/usr/lib/X11/fonts/Speedo/,/usr/lib
/X11/fonts/Type1/,/usr/lib/X11/fonts/misc/,/usr/lib/X11/fonts/cyrillic/,/usr/lib/X11/fonts/100dpi/,/
usr/lib/X11/fonts/75dpi/"
(--) Mach64: PCI: Mach64 RagePro rev 92, Aperture @ 0xe1000000,
Registers @ 0xe2000000, Block I/O @
0xc00100
---------------------------------
Does somebody know how to get the graphics card working ??
Thank you very much for any help,
best regards
Peter Biechele, Freiburg, Germany
Peter.Biechele@uni-freiburg.de
begin:vcard
n:Biechele;Peter
x-mozilla-html:FALSE
org:Universität Freiburg;Rechenzentrum
adr:;;;;;;
version:2.1
email;internet:Peter.Biechele@uni-freiburg.de
title:Dr.
x-mozilla-cpt:;27360
fn:Peter Biechele
end:vcard
Reply to: