Re: s390 hardware config
On Mar 24, 2006, at 7:35 PM, Stephen Frazier wrote:
It would seem that for a "hot plug" CTC device. You would set it up
to test for the presence of the other one of the pair. If they are
not both present then dont do anything. Thus in your example when
0A00 became available nothing would hapen as 0A01 was not
available. Then when 0A01 became available you could then activate
0A00.
I'm going to be devil's advocate here:
*I* always use the even address as the bottom one of the pair.
Is there anything mandating that that has to be the case?
Adam
Reply to: