ibook g3 airport problem
Hi there,
i got someproblems with my airport. I want to set an 128bit ascii wep
key. I'm running a 2.6.11 kernel image i installed with apt-get
install!
The error is:
ibook:/home/espo# iwconfig eth0 key "s:xxxx"
Error for wireless request "Set Encode" (8B2A) :
SET failed on device eth0 ; Operation not supported.
ibook:/home/espo#
And yes eth0 is my airport device.
Here iwconfig output and ifconfig output.
ibook:/home/espo# iwconfig
lo no wireless extensions.
eth1 no wireless extensions.
eth2 no wireless extensions.
sit0 no wireless extensions.
eth0 IEEE 802.11-DS ESSID:"WGLAN" Nickname:"espo"
Mode:Managed Frequency:2.462 GHz Access Point: 00:02:72:43:DB:7F
Bit Rate:0 kb/s Tx-Power=15 dBm Sensitivity:1/3
Retry limit:4 RTS thr:off Fragment thr:off
Power Management:off
Link Quality=49/92 Signal level=-46 dBm Noise level=-95 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:11
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
ibook:/home/espo#
ibook:/home/espo# ifconfig
eth0 Link encap:Ethernet HWaddr 00:30:65:21:B2:D9
inet addr:192.168.0.44 Bcast:192.168.0.255 Mask:255.255.255.0
inet6 addr: fe80::230:65ff:fe21:b2d9/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:965 errors:0 dropped:0 overruns:0 frame:0
TX packets:875 errors:1 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:695406 (679.1 KiB) TX bytes:187189 (182.8 KiB)
Interrupt:57
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:16 errors:0 dropped:0 overruns:0 frame:0
TX packets:16 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:800 (800.0 b) TX bytes:800 (800.0 b)
ibook:/home/espo#
mfg eSpo
Reply to: