Rory Campbell-Lange wrote:
I'm trying to get my airport card working on my ibook 800Mhz G3. It used to work fine, in multiple locations with my 2.4.25 kernel on my ibook 500Mhz! I'm not sure what I'm doing wrong -- I've installed wireless tools. I expected to see "hermes" and "orinoco" listed in lsmod, but if I try to insmod these they can not be found.
Did you build that kernel yourself? If so, I'm guessing you didn't build support for the Airport card into your kernel. Try doing 'modprobe airport', and see if the module loads. If not, you need to go into 'Networking devices/Wireless networking (non-hamradio)' and enable the Hermes and Orinoco drivers. One of the options under them, once they're enabled, will be for Apple Airport support.
eth1 Link encap:UNSPEC HWaddr 00-0A-95-FF-FE-E4-6A-F6-00-00-00-00-00-00-00-00
inet addr:192.168.181.11 Bcast:192.168.181.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
Yes, this is the eth1394 driver at work. -- Derrik Pates dpates@dsdk12.net