Re: best kernel config on PowerBook G4 12" 1.33GHz
> > But the riva fb driver does not work for me (PowerBook6,2) : after
> > having loaded the kernel, the display does not initialize correctly
> > and stays stucked to these lines :
> What is the PCIID of your card? Do you use any rivafb patches?
> Cheers,
> -- Guido
Hey,
as i got the same problem with the nVidia Card (becoming stuck at openpic)
i give you my PCIID:
0000:00:10.0 0300: 10de:0329 (rev a1)
for me i did not try any rivafb patches as you told they are just for
console<->X11 switching. When there is the possibility to make rivafb work
with some patches, i would like to try.
I attached the graphiccard part of lspci -vvx
cu
joerg
0000:00:10.0 VGA compatible controller: nVidia Corporation NV34M [GeForce FX Go5200] (rev a1) (prog-if 00 [VGA])
Subsystem: nVidia Corporation: Unknown device 0010
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66MHz+ UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 248 (1250ns min, 250ns max)
Interrupt: pin A routed to IRQ 48
Region 0: Memory at 91000000 (32-bit, non-prefetchable) [size=16M]
Region 1: Memory at a0000000 (32-bit, prefetchable) [size=128M]
Expansion ROM at 90000000 [disabled] [size=128K]
Capabilities: [60] Power Management version 2
Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-
Capabilities: [44] AGP version 3.0
Status: RQ=32 Iso- ArqSz=0 Cal=0 SBA+ ITACoh- GART64- HTrans- 64bit- FW+ AGP3- Rate=x1,x2,x4
Command: RQ=1 ArqSz=0 Cal=0 SBA- AGP- GART64- 64bit- FW- Rate=<none>
00: de 10 29 03 07 00 b0 02 a1 00 00 03 00 f8 00 00
10: 00 00 00 91 08 00 00 a0 00 00 00 00 00 00 00 00
20: 00 00 00 00 00 00 00 00 00 00 00 00 de 10 10 00
30: 00 00 00 90 60 00 00 00 00 00 00 00 30 01 05 01
Reply to: