airport eth1, onboard eth0 & eth1 Tx error, status 1
onboard eth0 is working flawlessly. have used dhclient-2.2.x and pump, both
without problems.
airport worked ONCE last evening. so here's the dilemma, and how i got there.
purchased a linksys BEFW11S4 wireless access point/router w/4port switch.
that AP connects via one of the LAN lines to my linux server which is set up
as a router, and gives out dhcp to three other boxes inhouse over cat5. my
ibook's airport card will not work and i'm uncertain why.
the AP has a web-interface, and wireless is turned on, and i can use the
airport card under osx.
running sid w/2.4.19-newpmac kernel, w/ airport, orinoco, and hermes modules
inserted.
i've reset the access point, i've searched google. what i haven't found is
some sort of guide that shows how to have the two eth's play nicely.
where can i begin to look for clues? eth1, on airport worked yesterday for a
moment before i went off to bed. Now, i receive:
eth1: Tx error, status 1 (FID=0143)
et al...
when rebooting, starting up, or doing a /etc/init.d/networking start, and
also if trying to use dhclient or pump.
i know this is a bit convoluted of a message. if anyone has a similar setup
or has conquered this, i'd love to hear it...
ken
__________________________________
http://llamakc.org GnuPG: 7C828670
<woot> Put *that* in you .sig and smoke it, Knghtbrd.
<Culus> You know he will read this :>
<woot> heheheheh.
--
To UNSUBSCRIBE, email to debian-powerpc-request@lists.debian.org
with a subject of "unsubscribe". Trouble? Contact listmaster@lists.debian.org
Reply to: