[Date Prev][Date Next] [Thread Prev][Thread Next] [Date Index] [Thread Index]

Re: 2.6 for DECstation, d-i



Hi Martin,

I've tested your 2.6 r4k kernel on my /260, and this is the result.

   * ECOFF kernels fails to boot from disk by delo,  so I had to use
     tftpboot (slow...)
   * You don't seem to have included the DEC serial drivers and console
     support for the /260, because after the prom-io I loose all output
     on the serial line (my /260 has serial console only).
   * When I let it boot without console, it will happily go multiuser.
     See boot messages below.
   * My second SCSI card does not seem to work as it should. Works OK
     under 2.4.27.

Regards,
Karel.


Linux version 2.6.16-1-sb1-bcm91250a (Debian 2.6.16-12) (waldi@debian.org) (gcc version 4.0.3 20051201 (prerelease) (Debian 4.0.2-5)) #2 Tue May 9 21:11:55 UTC 2006
This is a DECstation 5000/2x0
CPU revision is: 00000440
FPU revision is: 00000500
Determined physical RAM map:
memory: 10000000 @ 00000000 (usable)
On node 0 totalpages: 65536
 DMA zone: 65536 pages, LIFO batch:15
 DMA32 zone: 0 pages, LIFO batch:0
 Normal zone: 0 pages, LIFO batch:0
 HighMem zone: 0 pages, LIFO batch:0
Built 1 zonelists
Kernel command line: root=/dev/sda1 console=ttyS2
Primary instruction cache 16kB, physically tagged, direct mapped, linesize 16 bytes.
Primary data cache 16kB, direct mapped, linesize 16 bytes.
Unified secondary cache 1024kB direct mapped, linesize 32 bytes.
Synthesized TLB refill handler (21 instructions).
Synthesized TLB load handler fastpath (33 instructions).
Synthesized TLB store handler fastpath (33 instructions).
Synthesized TLB modify handler fastpath (32 instructions).
PID hash table entries: 2048 (order: 11, 32768 bytes)
Using 59.999 MHz high precision timer.
Dentry cache hash table entries: 65536 (order: 6, 262144 bytes)
Inode-cache hash table entries: 32768 (order: 5, 131072 bytes)
Memory: 256224k/262144k available (2270k kernel code, 5716k reserved, 414k data, 136k init, 0k highmem)
Calibrating delay loop... 59.86 BogoMIPS (lpj=233472)
Security Framework v1.0.0 initialized
SELinux:  Disabled at boot.
Capability LSM initialized
Mount-cache hash table entries: 512
Checking for 'wait' instruction...  unavailable.
NET: Registered protocol family 16
SCSI subsystem initialized
TURBOchannel rev. 1 at 25.0 MHz (without parity)
   slot 1: DEC      PMAZ-AA  V5.3d
audit: initializing netlink socket (disabled)
audit(1147360779.414:1): initialized
VFS: Disk quotas dquot_6.5.1
Dquot-cache hash table entries: 1024 (order 0, 4096 bytes)
Initializing Cryptographic API
io scheduler noop registered (default)
io scheduler anticipatory registered
io scheduler deadline registered
io scheduler cfq registered
rtc: I/O port 530579456 is not free.
RAMDISK driver initialized: 16 RAM disks of 8192K size 1024 blocksize
declance.c: v0.009 by Linux MIPS DECstation task force
declance0: IOASIC onboard LANCE, addr = 08:00:2b:37:63:76, irq = 16
declance0: registered as eth0.
SCSI ID 7 Clk 25MHz CCF=5 TOut 167 NCR53C9x(esp236)
SCSI ID 7 Clk 25MHz CCF=5 TOut 167 NCR53C9x(esp236)
ESP: Total of 2 ESP hosts found, 2 actually in use.
scsi0 : ESP236 (NCR53C9x)
esp0: hoping for msgout
 Vendor: COMPAQ    Model: ST34371N          Rev: 0388
 Type:   Direct-Access                      ANSI SCSI revision: 02
scsi1 : ESP236 (NCR53C9x)
esp1: hoping for msgout
 Vendor: COMPAQ    Model: ST34371N          Rev: 0682
 Type:   Direct-Access                      ANSI SCSI revision: 02
esp1: hoping for msgout
 Vendor: COMPAQ    Model: ST34371N          Rev: 0388
 Type:   Direct-Access                      ANSI SCSI revision: 02
esp1: hoping for msgout
 Vendor: COMPAQ    Model: ST34371N          Rev: 0388
 Type:   Direct-Access                      ANSI SCSI revision: 02
esp1: hoping for msgout
 Vendor: COMPAQ    Model: ST34371N          Rev: 0388
 Type:   Direct-Access                      ANSI SCSI revision: 02
esp1: hoping for msgout
 Vendor: COMPAQ    Model: ST34371N          Rev: 0682
 Type:   Direct-Access                      ANSI SCSI revision: 02
 Vendor: SONY      Model: CD-ROM CDU-55S    Rev: 1.0t
 Type:   CD-ROM                             ANSI SCSI revision: 02
SCSI device sda: 8386000 512-byte hdwr sectors (4294 MB)
sda: Write Protect is off
sda: Mode Sense: c7 00 10 08
SCSI device sda: drive cache: write through w/ FUA
SCSI device sda: 8386000 512-byte hdwr sectors (4294 MB)
sda: Write Protect is off
sda: Mode Sense: c7 00 10 08
SCSI device sda: drive cache: write through w/ FUA
sda: sda1 sda2 < sda5 >
sd 0:0:0:0: Attached scsi disk sda
esp1: Warning, live target 0 not responding to selection.
esp1: Resetting scsi bus
esp1: SCSI bus reset interrupt
esp1: SCSI bus reset interrupt
esp1: hoping for msgout
sd 1:0:0:0: scsi: Device offlined - not ready after error recovery
sd 1:0:0:0: rejecting I/O to offline device
sd 1:0:0:0: rejecting I/O to offline device
sd 1:0:0:0: rejecting I/O to offline device
sd 1:0:0:0: rejecting I/O to offline device
sdb : READ CAPACITY failed.
sdb : status=0, message=00, host=1, driver=00
sdb : sense not available.
sd 1:0:0:0: rejecting I/O to offline device
sdb: Write Protect is off
sdb: Mode Sense: 00 00 00 00
sd 1:0:0:0: rejecting I/O to offline device
sdb: asking for cache data failed
sdb: assuming drive cache: write through
sd 1:0:0:0: Attached scsi disk sdb
esp1: hoping for msgout
esp1: Warning, live target 1 not responding to selection.
esp1: Resetting scsi bus
esp1: SCSI bus reset interrupt
esp1: SCSI bus reset interrupt
esp1: hoping for msgout
sd 1:0:1:0: scsi: Device offlined - not ready after error recovery
sd 1:0:1:0: rejecting I/O to offline device
sd 1:0:1:0: rejecting I/O to offline device
sd 1:0:1:0: rejecting I/O to offline device
sd 1:0:1:0: rejecting I/O to offline device
sdc : READ CAPACITY failed.
sdc : status=0, message=00, host=1, driver=00
sdc : sense not available.
sd 1:0:1:0: rejecting I/O to offline device
sdc: Write Protect is off
sdc: Mode Sense: 00 00 00 00
sd 1:0:1:0: rejecting I/O to offline device
sdc: asking for cache data failed
sdc: assuming drive cache: write through
sd 1:0:1:0: Attached scsi disk sdc
esp1: hoping for msgout
esp1: Warning, live target 2 not responding to selection.
esp1: Resetting scsi bus
esp1: SCSI bus reset interrupt
esp1: SCSI bus reset interrupt
esp1: hoping for msgout
sd 1:0:2:0: scsi: Device offlined - not ready after error recovery
sd 1:0:2:0: rejecting I/O to offline device
sd 1:0:2:0: rejecting I/O to offline device
sd 1:0:2:0: rejecting I/O to offline device
sd 1:0:2:0: rejecting I/O to offline device
sdd : READ CAPACITY failed.
sdd : status=0, message=00, host=1, driver=00
sdd : sense not available.
sd 1:0:2:0: rejecting I/O to offline device
sdd: Write Protect is off
sdd: Mode Sense: 00 00 00 00
sd 1:0:2:0: rejecting I/O to offline device
sdd: asking for cache data failed
sdd: assuming drive cache: write through
sd 1:0:2:0: Attached scsi disk sdd
esp1: hoping for msgout
esp1: Warning, live target 3 not responding to selection.
esp1: Resetting scsi bus
esp1: SCSI bus reset interrupt
esp1: SCSI bus reset interrupt
esp1: hoping for msgout
sd 1:0:3:0: scsi: Device offlined - not ready after error recovery
sd 1:0:3:0: rejecting I/O to offline device
sd 1:0:3:0: rejecting I/O to offline device
sd 1:0:3:0: rejecting I/O to offline device
sd 1:0:3:0: rejecting I/O to offline device
sde : READ CAPACITY failed.
sde : status=0, message=00, host=1, driver=00
sde : sense not available.
sd 1:0:3:0: rejecting I/O to offline device
sde: Write Protect is off
sde: Mode Sense: 00 00 00 00
sd 1:0:3:0: rejecting I/O to offline device
sde: asking for cache data failed
sde: assuming drive cache: write through
sd 1:0:3:0: Attached scsi disk sde
esp1: hoping for msgout
esp1: Warning, live target 5 not responding to selection.
esp1: Resetting scsi bus
esp1: SCSI bus reset interrupt
esp1: SCSI bus reset interrupt
esp1: hoping for msgout
sd 1:0:5:0: scsi: Device offlined - not ready after error recovery
sd 1:0:5:0: rejecting I/O to offline device
sd 1:0:5:0: rejecting I/O to offline device
sd 1:0:5:0: rejecting I/O to offline device
sd 1:0:5:0: rejecting I/O to offline device
sdf : READ CAPACITY failed.
sdf : status=0, message=00, host=1, driver=00
sdf : sense not available.
sd 1:0:5:0: rejecting I/O to offline device
sdf: Write Protect is off
sdf: Mode Sense: 00 00 00 00
sd 1:0:5:0: rejecting I/O to offline device
sdf: asking for cache data failed
sdf: assuming drive cache: write through
sd 1:0:5:0: Attached scsi disk sdf
NET: Registered protocol family 2
IP route cache hash table entries: 4096 (order: 2, 16384 bytes)
TCP established hash table entries: 16384 (order: 4, 65536 bytes)
TCP bind hash table entries: 16384 (order: 4, 65536 bytes)
TCP: Hash tables configured (established 16384 bind 16384)
TCP reno registered
TCP bic registered
NET: Registered protocol family 1
NET: Registered protocol family 17
kjournald starting.  Commit interval 5 seconds
EXT3-fs: mounted filesystem with ordered data mode.
VFS: Mounted root (ext3 filesystem) readonly.
Freeing unused PROM memory: 124k freed
Freeing unused kernel memory: 260k freed
Warning: unable to open an initial console.
Adding 208804k swap on /dev/sda5.  Priority:-1 extents:1 across:208804k
EXT3 FS on sda1, internal journal





Reply to: