On Sun, Oct 06, 2002 at 08:25:59PM +0200, Karsten Merker wrote:
> I have experienced no problems before, so I have tested this now again (also
> on a /150), using cu for the installation itself (as recommended in the
> installation manual) and then, after base-config was complete, logged in on
> serial console via minicom and edited /etc/apt/sources.list with nano and
> experienced no problems with it. I have not installed any additional
> packages beyond base.
> I have also re-run base config in minicom and re-did all steps including
> manually editing sources.list - also no problems.
> The only difference I can see between your setup and mine is that you were
> using minicom from the beginning. I will retry a full base install using
> minicom.
I just tried again with minicom - logging in - using nano - No problems.
It didnt work from base-config on initial boot though. I havent checked
the TERM var ...
Flo
--
Florian Lohoff flo@rfc822.org +49-5201-669912
Heisenberg may have been here.
Attachment:
pgpjM5YVJh_B4.pgp
Description: PGP signature