Re: Failed to build Ginko CADx
On Wed, Jun 08, 2011 at 11:26:22AM +0200, Andreas Tille wrote:
> make[3]: *** No rule to make target `/usr/lib/libdl.so', needed by `src/cadxcore/libCADxCore.so.2.4.1.1'. Stop.
I suspect removing the --parallel in
dh $@ --buildsystem=cmake --parallel
will solve this problem. I was remembering this when looking at #629815
which is the very same problem (and the rules file is also featuring the
parallel build). The test build is running but will probably not be
finished before I fell asleep.
As a general note: In the past I *always* was observing problems with
parallel builds at some point in time / specific architecture. I would
suggest to not use this option.
Kind regards
Andreas.
--
http://fam-tille.de
Reply to: