On Tuesday 22 February 2005 11:51 pm, João Paulo Vanzuita wrote: > sorry about to mail again, but maybe 2.6.10 dont work on my laptop. > > - dell latitude cpx > .ethernet controller: xircom cardbus ethernet 10/100 > > i instaled woody with 2.4.18, upgraded to unstable, compiled a new > kernel(2.6.10). > > on 2.4.18 all works fine, i do lspci and can see pcmcia network card there, > connect, etc. on 2.6.10 all works, less network pcmcia, have compiled the > newest pcmcia-cs and no pcmcia card was found, using lspci i can see all > adapters, less network card. > > trying 'ifconfig eth0 up' , got 'eth0: ERROR while getting interface flags: > No such device' Ok, I have same laptop with the same pcmcia xircom ethernet card. I am running Debian unstable with a self compiled 2.6.10 kernel from the Debian unstable archive kernel-source-2.6.10_2.6.10-5_all.deb sources. If you want to use my .config file for your system, find it attached. It should work. If you are compiling your own kernels, I don't need to tell you what to do with the file. I do not use an initrd and compile a lot of stuff into the kernel, so you could probably trim it down some. But if you want a kernel that works with a Dell Latitude Cpx with the Xircom ethernet card, then this one does a fine job. You may have post your /etc/network/interfaces file for us to see if it is setup correctly. When I take my laptop out of suspend, from root, I issue the command cardctl insert which turns the card back on, then I issue the command /etc/init.d/networking restart and get an ip address and connect to the local network. I am sure there is an easier way, but this is relatively quick and works every time. I haven't had the desire to research a more automatic way. -- Stewart... They took the fourth amendment and I was quiet because I didn't deal drugs When they took the sixth amendment, I was quiet because I was innocent. When they took the second amendment, I was quiet because I didn't own a gun Now they've taken the first amendment, and I can say nothing about it.
Attachment:
config-2.6.10.bz2
Description: BZip2 compressed data