Re: Reconfiguring Network after Upgrade.
-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1
On Fri, Mar 15, 2002 at 12:31:52PM -0000, William Reece wrote:
[...snip...]
> ... I could no longer get online.
> I am on a windows network connected to a cable modem (dynamic IP
> reassigned every 12 hours or so) via a sygate home network server
> (http://www.sygate.com/swat/products/gate_ov.htm).
[...snip...]
'could not get online' is a bit ambiguous. Can you access your LAN, but
not the internet?
>
> eth0
> Link encap:Ethernet HWaddr 00:E0:18:1A:81:E3
> inet addr:192.168.0.2 Bcast:192.168.0.255 Mask:255.255.255.0
> UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
> RX packets:169 errors:0 dropped:0 overruns:0 frame:0
> TX packets:25 errors:0 dropped:0 overruns:0 carrier:0
> collisions:0 txqueuelen:100
> RX bytes:11396 (11.1 KiB) TX bytes:3438 (3.3 KiB)
> Interrupt:5 Base address:0xb000
This output is consistent with an interface that is set up and properly
configured. The second line shows that you have an IP address (I assume
this comes from your sygate server.) Are you able to access other
machines on your LAN and/or the gateway? If you can access your LAN, but
not the internet, then it's probably a routing problem. What is the
output of 'route -n'?
[...snip...]
>
> I also tried pump which again didn't work, it seems to stop responding.
It appears you already have an address through DHCP, which means that
pump (or dhclient, etc.) is already running. That is why it is hanging
when you try to run it.
HTH & HAND,
- --
Mike Alborn <malborn@odoitau.dyn.dhs.org>
# http://odoitau.dyn.dhs.org
# PGP Key ID: C36DC30B signed/encrypted mail preferred
Genius is one percent inspiration and ninety-nine percent perspiration.
-- Thomas Alva Edison
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.0.6 (GNU/Linux)
Comment: For info see http://www.gnupg.org
iEYEARECAAYFAjySKV0ACgkQmyUqpsNtwwtghACgikV+WxZf2GQPknDmIYC51nzo
z34AniKH59Fz+dL1+Ueze7ve29H5LYnf
=6O03
-----END PGP SIGNATURE-----
Reply to: