[Date Prev][Date Next] [Thread Prev][Thread Next] [Date Index] [Thread Index]

Re: ESS ES1989 Modem with Kernel 2.4

Hi,
I've got the same problem with my Asus laptop. It is a winmodem, integrated on the sound chip. There are no linux drivers for this winmodem AFAIK. Too bad as I would like to have a driver for it as much as you would. 

Buon Natale.

René.

Ralf Gerlich wrote:


Hi all!
I'm searching for a way to get my ESS ES1989 Modem to work with Linux 2.4. I've heard there were binary drivers by ESS Tech. for 2.2, but (as if I didn't expect this) they don't seem to work with 2.4. 

I attached the output lspci -vv produces for the Modem and Audio Card.

Thanx for any support,

Ralf



------------------------------------------------------------------------

00:06.0 Multimedia audio controller: ESS Technology ES1988 Allegro-1 (rev 12)
	Subsystem: Asustek Computer, Inc.: Unknown device 1049
	Control: I/O+ Mem- BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
	Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
	Latency: 32 (500ns min, 6000ns max)
	Interrupt: pin A routed to IRQ 10
	Region 0: I/O ports at f800 [size=256]
	Capabilities: [c0] Power Management version 2
		Flags: PMEClk- DSI+ D1+ D2+ AuxCurrent=0mA PME(D0-,D1+,D2+,D3hot+,D3cold-)
		Status: D0 PME-Enable- DSel=0 DScale=0 PME-

00:06.1 Communication controller: ESS Technology ESS Modem (rev 12)
	Subsystem: Asustek Computer, Inc.: Unknown device 1049
	Control: I/O- Mem- BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
	Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
	Interrupt: pin A routed to IRQ 10
	Region 0: I/O ports at f400 [disabled] [size=256]
	Capabilities: [c0] Power Management version 2
		Flags: PMEClk- DSI+ D1+ D2+ AuxCurrent=100mA PME(D0-,D1+,D2+,D3hot+,D3cold+)
		Status: D0 PME-Enable- DSel=0 DScale=0 PME+





--
René Seindal (rene@seindal.dk)              http://www.seindal.dk/rene/
Reply to: