Re: installing w/udma66
On Sat, Mar 31, 2001 at 04:00:15PM -0500, Dave Linsalata wrote:
> I was wondering - if I have an udma66 HD, can I use the udma66 installation
> disk set to install Debian with the HD on the ata/66 channel? Or do I still
> have to switch it to the ata/33 channel to install it?
Possibly this Problem is related:
I'm using kernel 2.4.2 and get the following messages:
PCI: Using IRQ router PIIX [8086/7110] at 00:07.0
got res[10000000:10000fff] for resource 0 of Ricoh Co Ltd RL5c476 II
got res[10001000:10001fff] for resource 0 of Ricoh Co Ltd RL5c476 II (#2)
Limiting direct PCI/PCI transfers.
^^^^^^^^
...
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
^^^^^^^^^^^^^^
PIIX4: IDE controller on PCI bus 00 dev 39
PIIX4: chipset revision 1
PIIX4: not 100% native mode: will probe irqs later
ide0: BM-DMA at 0x1040-0x1047, BIOS settings: hda:DMA, hdb:pio
ide1: BM-DMA at 0x1048-0x104f, BIOS settings: hdc:pio, hdd:pio
hda: HITACHI_DK23BA-20, ATA DISK drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
What is limited here and why is 33MHz assumed if I have UDMA 66MHz?
These kernel messages are new since kernel 2.4.2 (which are reported
by logcheck.
Kind regards
Andreas.
Reply to: