[debian-knoppix] Re: Set CONFIG_SCSI_MULTI_LUN to Y
Steve wrote:
> At 03:14 PM 7/3/03 , Klaus Knopper wrote:
> >On Thu, Jul 03, 2003 at 01:55:24PM -0400, Steve wrote:
> >> Could you elaborate on that? I may be a bit confused. Is the 0 0 0 1
> >not
> >> chosing LUN 1? Thanks.
> >
> >It's chosing LUN1 for Controller 0, Channel 0, SCSI ID 0.
> >
> >Are you sure that your device was given this exact SCSI path by hotplug?
> >Did you check with dmesg?
>
> This is what I get with dmesg with Knoppix (unrelated items snipped)
> usb.c: registered new driver usb-storage
> scsi1 : SCSI emulation for USB Mass Storage devices
> Vendor: SanDisk Model: ImageMate CF-SM Rev: 0100
> Type: Direct-Access ANSI SCSI revision: 02
> Attached scsi removable disk sda at scsi1, channel 0, id 0, lun 0
So your card is on scsi bus (controller) 1, not bus 0 =>
echo "scsi add-single-device 1 0 0 1" > /proc/scsi/scsi
Regards...
Michael
_______________________________________________
debian-knoppix mailing list
debian-knoppix@linuxtag.org
http://mailman.linuxtag.org/mailman/listinfo/debian-knoppix
Reply to: