Re: [debian-knoppix] knoppix from hd
--- Conrad Newton <conrad.newton@broadpark.no> wrote:
> From mark everton on Tuesday, 2003-07-01 at 05:29:32
> -0700:
> What little I once knew about lilo I have forgotten
> during the time that I have been using grub,
I wouldn't mind on using grub if it did the job :)
>so maybe
> someone else can help you here. The following is
> probably wrong, but maybe close enough that you
> can figure out the rest yourself . . .
>
> boot=/dev/hda3
> image=/vmlinuz
> root=/dev/hda3
>
> It is possible however that you did everything
> correctly
> except for one point: to boot from hard disk you
> need
> an /etc/fstab, which is not there initially. A
> minimal
> example might look like this:
>
> # /etc/fstab: filesystem table.
> #
> # filesystem mountpoint type options dump pass
> /dev/hda3 / ext2 defaults 0 1
> /dev/hdaX none swap sw 0 0
> proc /proc proc defaults 0 0
> /dev/fd0 /floppy vfat
> defaults,user,noauto,showexec,umask=022 0 0
> /dev/cdrom /cdrom iso9660
> defaults,ro,user,noexec,noauto 0 0
>
> Here you need to change the "X" in hdaX to the right
> value
> for your swap partition. You did make hda3 into an
> ext2
> filesystem, did you not? That is important, too.
>
Klause Knopper should know about this. (I think)
Where is he? Buzzy preparing for linuxtag?
I wish I could come :(
Klause, If you know about what I am trying to do here,
I would appreceat if you would help me.
Thanks
Mark
__________________________________
Do you Yahoo!?
SBC Yahoo! DSL - Now only $29.95 per month!
http://sbc.yahoo.com
_______________________________________________
debian-knoppix mailing list
debian-knoppix@linuxtag.org
http://mailman.linuxtag.org/mailman/listinfo/debian-knoppix
Reply to: