gnu-19990907.tar.gz
Figured I was letting my current install rot, so I decided to go the
tarball way so I was fresh and (reasonably) up to date.
Needless to say, GNUMach, right around the spot where
it loads/uses serverboot.gz, says:
hd02: bad access (sector etc info here)
I know it has to do with serverboot.gz because if I supply an incorrect
path, GNUMach says it can't find it, asks me to enter a correct one,
and gives that message right after.
I performed a badblock check on the partition (destructive and
non-destructive) as well. No reports.
Anyway, I don't know if any of the above is relevant, but the
system locks up after it loads exec, proc, init, auth.
It writes a newline after "auth." and sits there.
Known problem? I tried recreating the filesystem and reuntargzing it
and it still persists. I'm asking because I don't want to download 12 megs
again without being sure that it's absolutely necessary. :)
/* ----------
Michael Bacarella( mbac@nyct.net ) | (212) 293-2620
Administration / Development / Support | http://nyct.net/
[ N e w Y o r k C o n n e c t . N E T ] | info@nyct.net
Bringing New York The Internet Service It Deserves!
--------- */
Reply to: