Hello guys,
I´m trying to install Debian on my
server.
Some hardware descriptions:
- Inel Xeon processor
- 03:01.0 RAID bus controller: Adaptec (formerly
DPT) SmartRAID V Controller (rev 01)
There is configured by hardware one RAID 5 on four
scsi disks of 73GB.
I tryed with Lenny and Squeeze versions
and both presented the same error when the install try to install
grub:
main-menu[1250]: INFO: Falling back to the
package description for auto-install
main-menu[1250]: INFO: Falling back to the package description for ai-choosers main-menu[1250]: INFO: Menu item 'grub-installer' selected grub-installer: info: architecture: i386/generic main-menu[1250]: WARNING **: Configuring 'grub-installer' failed with error code 1 main-menu[1250]: WARNING **: Menu item 'grub-installer' failed. The disk partitioner find the array on
/dev/i2o/hdax depending of my partition table, I guess that my array should
be
on /dev/sdax, my partition table is
below:
/boot - primary partition 200MB (ext3) - flag
boot on
LVM´s
/ -
lvm 30GB (ext3)
/var/log - lvm 20GB (ext3) /var - lvm 150GB (ext3) swap - lvm 2GB (linux swap) This problem is in the kernel that don´t load by
default i2o drivers?
PS: I installed Ubuntu Server 9.10 and it work
fine, the grub was installed with no problems.
Question: There is a bug with Debian installer
when work with Adaptec controllers? I´m looking for solutions but
I not found one yet.
Thanks for attention,
Cristian
|