Re: powerpc daily sid_d-i CD builds working again

[Yves-Alexis Perez <corsac@corsac.net>]

On Tue, 2006-05-16 at 08:23 +0200, Sven Luther wrote:
> On Tue, May 16, 2006 at 12:17:10AM +0200, Yves-Alexis Perez wrote:
> > 0 OFfb ATY,264LTP
> > 1 OFfb ATY,264LTP
> 
> Ok, this is atyfb, and you probably have a rage something chip in there. I
> wonder about the two fbdevs, but i suppose this is one for the external port,
> and one for the LCD panel. Do you per chance have an external monitor
> connected ?

No, but I can connect one if needed.
> 

> > dmesg says nothing about framebuffer. The .config is the one used when
> > generating powerpc gtk installer, don't know where to find it.
> 
> Ok.

But syslog does. See http://heracles.corsac.net/~corsac/hydra/syslog

Jan  1 00:02:32 kernel: atyfb: using auxiliary register aperture
Jan  1 00:02:32 kernel: atyfb: 3D RAGE LT PRO (Mach64 LI, PCI) [0x4c49 rev 0xdc]
Jan  1 00:02:32 kernel: atyfb: 8M SDRAM (1:1), 29.498928 MHz XTAL, 230 MHz PLL, 100 Mhz MCLK, 100 MHz XCLK
Jan  1 00:02:32 kernel: atyfb: monitor sense=62b, mode 6
Jan  1 00:02:32 kernel: Console: switching to colour frame buffer device 128x48
Jan  1 00:02:32 kernel: atyfb: fb0: ATY Mach64 frame buffer device on PCI
> 
> > > Or alternatively give us the lspci output corresponding to your graphic card,
> > > and the kernel version used, and i will investigate for you.
> > 
> > Linux 2.6.16-1-powerpc
> > lspci isn't very verbose at the moment because there are only "unknown
> > devices".
> 
> Try lspci -n.

http://heracles.corsac.net/~corsac/hydra/lspci

-- 
Yves-Alexis Perez