08.10.2004 о 12:43 +0100 Dan Peachey написав(-ла): > Hi there, > > I've had a go at installing a system using the pre-rc2 netinst image. With the > install I have 2 x HDD which I have setup a software RAID for in partman > (/dev/md/0). I have then fired up a console and used pvcreate and vgcreate to > create LVM groups. Going back to partman, it recognises the LVM VG and allows > me to setup logical volumes. All goes smooth and I have an LV partition > with /root mounted on it and a number of other LV's. No complaints from the > installer, but when I get to installing the boot loader (LILO) it bombs out > and will not let me install to /dev/md/0. I do not think that lilo can be booted from md device, try to use one of the physical volumes of this device (or disk device). Does lilo-installer display any disk devices (hda, sda...) in the menu? > I was expecting to see GRUB as the > boot loader as this has been in previous releases? But I guess GRUB might > have failed too. So I'm a bit stuck how to get this to work. Any help greatly > appreciated. > GRUB probably cannot boot operating system from LV, lilo can. > TIA, Dan -- Eugeniy Meshcheryakov Kyiv National Taras Shevchenko University Information and Computing Centre http://icc.univ.kiev.ua
Attachment:
signature.asc
Description: Digital signature