(hd1,0) != (hd0,0)
I installed sarge using the most recent install cd "pre-rc2". I loved
it. I ran using the linux26 option for the newest kernel. I did
encounter one problem. I installed to a new partition on my sata
hardrive "/dev/sda1". I installed grub. When I rebooted grub assumed
that my settings should be (hd1,0). I had little problem updating my
grub configuration to reflect (hd0,0). I suspect that it has something
to do with an assumption that I would try to boot to the ide drive on my
computer. I will begin to dig threw the code to see if I can locate the
exact problem. I was just curious if any one had experienced a similar
problem.
Reply to: