Bug#248627: Debian Installer version 4 - Installation report
On Thu, Jun 03, 2004 at 11:52:58PM +0200, Thorsten Schaefer wrote:
> I've done about six further installations. Everytime the Xircom PCMCIA
> network card (REM56G-100) is used, the network card worked during the
> initial installation process, didn't work after the first reboot (so during
> the installation part that follows) and after all following reboots works.
> To verify if it is possible to get the network running after the first
> reboot I've run an /etc/init.d/networking restart (and also tried with stop
> and start) but the command didn't succeed. The message "Reconfiguring
> network interfaces" is displayed. Also an "init 1" and then "init 3" didn't
> make a difference.
I've got an RBEM56G-100, which I assume is similar. I've discovered
that it doesn't work if the "xircom_tulip_cb" module is loaded, but does
work if only the "xircom_cb" module is loaded.
Could you please run "lsmod | grep xircom" to check which one it's
using? Perhaps discover is choosing the wrong module.
--
Nicholas Breen
nbreen@ofb.net
Reply to: