Bug#246858: installation-reports
Package: installation-reports
Debian-installer-version: <20040501 Beta4 from Debian.org>
uname -a: <Won't get that far...>
Date: <20040501 2300>
Method: <Trying to install from a CDROM>
Machine: <Dell Latitude Cpt 400GT>
Processor: Celeron 466 MHz
Memory: 128 MB
Root Device: <IDE >
Root Size/partition table: <Feel free to paste the full partition
table, with notes on which partitions are mounted where.>
Output of lspci:
Base System Installation Checklist:
Initial boot worked: [O ]
Configure network HW: [E ]
Config network: [ E]
Detect CD: [E ]
Load installer modules: [ O]
Detect hard drives: [ E]
Partition hard drives: [ E]
Create file systems: [E ]
Mount partitions: [ E]
Install base system: [ E]
Install boot loader: [ E]
Reboot: [ O]
[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it
Comments/Problems:
System boots from CD and goes through
1) Choose Language
2) Choose Country
3) Choose Keyboard Layout
It then spins up the CD it just booted from but suddenly can't read from or
find when trying to mount and copy modules.
After a minute or two I get :
"A problem occured when data was read from the CD-ROM. Make sure it's still
in the drive. If you try again and it doesn't work, verify your CD so that
it is error free
Couldn't copy from CDROM. Try again?"
At this point all connection to the CDROM is gone. A retry can't find our
mount the CD. And verification doesn't work as no reading from the CD occur
when chosen.
A reboot boots the machine off the CD but get stuck as above again
regardless of 2.4 or 2.6 Kernel.
CD works fine on my desktop though so I don't think the CD is faulty.
_________________________________________________________________
Hitta rätt på nätet med MSN Sök http://search.msn.se/
Reply to: