Bug#243892: Package: installation-reports
Package: installation-reports
Debian-installer-version:
http://gluck.debian.org/cdimage/testing/sarge_d-i/i386/beta3/sarge-i386-netinst.iso
uname -a: Linux maulwurf 2.4.25-1-386 #1 Tue Feb 24 08:11:13 EST 2004 i686
GNU/Linux
Date: 2004-04-14
Method: netinst, boot from cdrom, http://ftp.de.debian.org
Machine: IBM Thinkpad 600
Processor: PII-266
Memory: 288 MB
Root Device: IDE
Root Size/partition table:
maulwurf:~# cat /etc/fstab
# /etc/fstab: static file system information.
#
# <file system> <mount point> <type> <options> <dump> <pass>
proc /proc proc defaults 0 0
/dev/hda6 /transfer vfat defaults 0 2
/dev/hda9 none swap sw 0 0
/dev/hda8 / ext3 defaults,errors=remount-ro 0 1
/dev/hda7 /home ext3 defaults 0 2
/dev/hda10 /work ext3 defaults 0 2
Output of lspci:
maulwurf:~# lspci
pcilib: Cannot open /sys/bus/pci/devices
0000:00:00.0 Host bridge: Intel Corp. 440BX/ZX/DX - 82443BX/ZX/DX Host
bridge (AGP disabled) (rev 02)
0000:00:02.0 CardBus bridge: Texas Instruments PCI1250 (rev 02)
0000:00:02.1 CardBus bridge: Texas Instruments PCI1250 (rev 02)
0000:00:03.0 VGA compatible controller: Neomagic Corporation NM2160
[MagicGraph 128XD] (rev 01)
0000:00:07.0 Bridge: Intel Corp. 82371AB/EB/MB PIIX4 ISA (rev 01)
0000:00:07.1 IDE interface: Intel Corp. 82371AB/EB/MB PIIX4 IDE (rev 01)
0000:00:07.2 USB Controller: Intel Corp. 82371AB/EB/MB PIIX4 USB (rev 01)
0000:00:07.3 Bridge: Intel Corp. 82371AB/EB/MB PIIX4 ACPI (rev 01)
Base System Installation Checklist:
Initial boot worked: [O]
Configure network HW: [E]
Config network: [E]
Detect CD: [O]
Load installer modules: [O]
Detect hard drives: [O]
Partition hard drives: [O]
Create file systems: [O]
Mount partitions: [Ó]
Install base system: [O]
Install boot loader: [O]
Reboot: [O]
[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it
Comments/Problems:
I use a Xircom Realport Ethernet/Modem-Card in a DHCP environment; my
network card allways gets the same IP address according to it's MAC address.
The sarge netinst-image beta 3 booted without any option given, but there is
no network.
My "workaround" was to switch to another console, entered "ifconfig", found
that there was no interface than "lo", did "/etc/init.d/pcmcia restart"
followed by "/etc/init.d/networking restart" and finally i got my ip address
via dhcp. Then i successfully did the installation from ftp.de.debian.org,
but after a reboot the network has gone again.
Despite that, the sarge-netinst-image is ok, but the german translators
should spell-check again...
--
NEU : GMX Internet.FreeDSL
Ab sofort DSL-Tarif ohne Grundgebühr: http://www.gmx.net/info
Reply to: