Bug#222223: installation-reports
Package: installation-reports
Version: Debian Installer beta 1
INSTALL REPORT
Debian-installer-version:
http://gluck.debian.org/cdimage/testing/netinst/i386/beta-1/sarge-i386-netinst.iso
downloaded on 2003-11-20
uname -a: N/A
Date: 2003-11-20
Method: CD
Machine: Intel ISP 2150G
Processor: 2 x PIII 600 MHz
Memory: 1 GB
Root Device: sda
Root Size/partition table: N/A
z opisem, które partycje były gdzie zamontowane.>
Output of lspci:
Base System Installation Checklist:
Initial boot worked: [ E ]
Configure network HW: [ ]
Config network: [ ]
Detect CD: [ ]
Load installer modules: [ ]
Detect hard drives: [ ]
Partition hard drives: [ ]
Create file systems: [ ]
Mount partitions: [ ]
Install base system: [ ]
Install boot loader: [ ]
Reboot: [ ]
[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it
Comments/Problems:
Kernel oops right at the beginning, while booting the kernel. The last
messages are
PCI: Probing PCI hardware (bus 00)
general proteacion fault: 0000
CPU: 0
[ ... and there goes the oops stuff.... ]
<0>Kernel panic: Attempted to kill init!
Regular sarge snapshot CD boots fine, though the installer freezes later
while discovering SCSI controller... Knoppix (based on 2.4.22) works fine on
this machine, so basically the hardware is not a problem. Woody also worked
on this machine for some 2-3 years, though I don't know which kernel
version, as the server was leased to a third party at that time - I suspect
it was 2.4.x, as there's Adaptec 2100S RAID controller inside, which is
basically supported only by 2.4+ kernels.
Reply to: