[Date Prev][Date Next] [Thread Prev][Thread Next] [Date Index] [Thread Index]

Re: Sheevaplug will not finish booting after kernel update

On Mon, Oct 25, 2010 at 11:15:20AM -0700, Jason Graham wrote:
> Hi,
> I'm running a Sheevaplug on Debian Lenny.  This morning I updated the
> kernel to the one that was released today, and afterwards my
> Sheevaplug would not finish booting.  In retrospect, I realize I
> forgot to run `flash-kernel` after upgrading, but I don't think this
> is the root issue, since I have forgot this step in the past, and the
> machine would just reboot into the previous kernel, at which point I
> could correct my mistake and reboot again.
> I connected via the USB-serial port, and watched it run through the
> drive checks (I had to disconnect the power to move it over to my main
> machine, causing the USB hard drive to not be unmounted properly) and
> then freeze afterwards.
> At this points, I connected the hard drive to my desktop machine to
> back-up my data, used GParted to check the disk integrity and cause
> the disk to believe it had been properly unmounted, and reconnected it
> to my plug.
> After several reboots of the plug, I keep getting dropped into the
> BusyBox shell, and I cannot figure out the error.
> My plug is configured as described by Martin Michlmayr on his website
> [1].  I have attached a boot log, which contains a printout of the
> `printenv` command.
> [1]:http://www.cyrius.com/debian/kirkwood/sheevaplug/unpack.html

I forgot my attachment.

Jason Graham, Graduate Student
School of Electrical Engineering and Computer Science
Email: jgraham@eecs.wsu.edu, PGP-Key ID: 1024D/BC298D3F

Attachment: screen-log.log.gz
Description: Binary data

Reply to: